Electronics Forum | Thu Aug 06 12:46:15 EDT 2009 | jorge_quijano
Yes, it is centered, in fact is the same product we run everyday, problem shows up after maintenance was performed.
Electronics Forum | Tue May 04 14:45:40 EDT 2010 | bruna
Hello Does anyone can give feedback about this two analyzers (zirox and delta f 150)? In fact we are trying to understand which is better for wave soldering, benefits and prejudice. Does anyone work with both? Thanks
Electronics Forum | Fri Apr 22 14:19:29 EDT 2011 | cbeneat
Patrick, It actually seems to go away after every adjustment. Whether it's flux, heat, doesn't matter but it always reappears. The part that has me baffled is the fact that another identical part is approx. 4 mm away, and never affects this one.
Electronics Forum | Tue May 10 17:26:02 EDT 2011 | jamike
hmmm I don't think i'l get away with that one, the staff do not grasp the fact that if we do not maintain an acceptable efficiency their jobs are at risk to going to Asia or the company folding completely.
Electronics Forum | Thu Jul 21 11:13:25 EDT 2011 | kahrpr
we use turtle wax on a more serous note, I bet those two products are similar in the fact it you fill the ridges in the aperture walls you will get better release. They may be closer than you think.
Electronics Forum | Wed Aug 24 16:30:10 EDT 2011 | hussman
Low and behold, the answer has been found. I guess 2512 parts are not used inthe automotive wolrd due to the fact that they crack during thermal cycling!
Electronics Forum | Wed Nov 16 14:57:57 EST 2011 | austinpeterman
Hello Don, We dont heat cure any of our assemblies. We coat relitively few boards and just let them cure at room temp. Perhaps we should start heat curing. In fact, we have an old, fully functional, heller 1500 just sitting in storage. Hmmm. . .
Electronics Forum | Sat Nov 10 03:50:47 EST 2012 | ericrr
Interesting question, however I dont think this problem is within the scope of this forum, in fact some questions more focused on SMT are harder to answer here, Or to put it another way you would get a answer faster if you found some other forum to a
Electronics Forum | Thu Oct 11 15:42:44 EDT 2012 | anvil1021
Yes they are but not durectly in the center,I was also noticing that even our passive components have voids where the microvias are? As a matter of fact there are up to 5 microvias in the passive pads? There was a previous design that had the micro
Electronics Forum | Fri Apr 26 16:26:55 EDT 2013 | emeto
Hi, thanks for your answer. I was thinking to go even deeper by counting the hours the paste was exposed, but it probably doesn't make a lot of sense, especially considering the fact that my operators will add paste when the level goes too low. I wi