Electronics Forum | Sat Jan 22 01:56:54 EST 2000 | Hany
HI Tony: We have the same case last month & we tried to fold a little sheet of metal (stainless steel I guess)on the fingers edge & it has worked perfectly. Only one fault among more than 1000 Pcs & it was referred to a manual error. You can try it,
Electronics Forum | Thu Jan 13 12:36:09 EST 2000 | Wolfgang Busko
Tony: Have a mask applied by the boardhouse which can be removed after soldering. We worked with pallets or tape but had bad luck with some boards. At present I would prefer a mask. M2C Wolfgang
Electronics Forum | Thu Jan 13 12:47:03 EST 2000 | morris
Wolfgang: What is the mask material? What type of process/tools are required to remove it? Approximate cost per PCB?
Electronics Forum | Mon Aug 02 11:21:29 EDT 2004 | sforman1
Use MicroCoat Technologies UV cure solder mask. will leave PCB absolutely clean. used in many PCB solder/wirebonding apps. http://www.m-coat.com
Electronics Forum | Mon Aug 02 11:44:49 EDT 2004 | jbabson1
If you do wire bond before printing, Photo Stencil (www.photostencil.com)can help you design a stencil with relief on the pwb side for the wirebonding.
Electronics Forum | Fri Jan 14 08:56:55 EST 2000 | Wolfgang Busko
Hi Morris, Not that I�m forced to do it at the moment but if I had to again in the future I would try a different way and than look for a masking method that goes along with our other processes. I�ve just seen this in board houses and they offered u
Electronics Forum | Wed Jun 25 09:42:09 EDT 2003 | caldon
SR. Here is a shot in the dark but have you try'd KNS? I know they have been working on some cool polymers...send them a note as they may have something that meets your needs. They may not have anything that can be removed but it is worth a try. pol
Electronics Forum | Sun Jan 23 03:23:09 EST 2000 | Rob Steltman
Hi We use a U-channel piece of high temperature silicon which is just pushed over the gold tabs before the soldering process. The silicon can be used over and over again. The advantages are that there is no mask on the board during the SMT process a
Electronics Forum | Fri Oct 05 18:59:53 EDT 2001 | Dan Steffler
I have had an issue where solder has contaminated gold plated pads (fingers) where it is not acceptable. The pads must remain perfectly coplaniar for a LCD zebra strip to lay accross them. Does anyone know of a way to remove the marriage level of s
Electronics Forum | Tue Jun 28 18:20:49 EDT 2005 | russ
Matt, have you run a profile on this board? Just because it's .062" doesn't mean that any old .062" profile will work. We have .062" thick boards that almost nil for copper and other are utilizing 2 oz. layers internally. They require quite diffe