Electronics Forum | Fri Apr 13 13:45:25 EDT 2001 | gsmguru
Just a guess-- Could you be seeing the nickel under the gold plating because you are removing some of the Gold with the Kapton Tape ? This should be easy to verify. Otherwise it sounds like things are pretty much covered.
Electronics Forum | Thu Jan 13 12:36:09 EST 2000 | Wolfgang Busko
Tony: Have a mask applied by the boardhouse which can be removed after soldering. We worked with pallets or tape but had bad luck with some boards. At present I would prefer a mask. M2C Wolfgang
Electronics Forum | Thu Jan 13 12:47:03 EST 2000 | morris
Wolfgang: What is the mask material? What type of process/tools are required to remove it? Approximate cost per PCB?
Electronics Forum | Thu Oct 07 20:34:48 EDT 1999 | Tony Huang
Hi, Does anybody know what is the minimum gold plating thickness on the PCB goldfinger required by the industrial specifications - IPC, Bellcore, etc. Where can I find the information? Appreciate for the help! Thanks, Tony
Electronics Forum | Tue Jul 13 18:18:39 EDT 1999 | King Kong
Hi All, Does any one experienced the solder on gold finger after reflow. Its about 5 to 8 mils diameter . We'd clean the entire screen printer, mounter & reflow as well, but doesn't help much.
Electronics Forum | Tue May 19 12:54:55 EDT 1998 | Richard Jackson
| We had a similar problem. But whenever the solder came from the screen printer the solder would wet to the gold fingers, with the help of residual flux. But the problem is balls, that I assume are not wetted to the gold fingers but instead are jus
Electronics Forum | Tue May 19 12:59:13 EDT 1998 | Mike
| Does any one know how to attach a picture to one of these posts? If it is possible I will attach a picture of what it is I'm seeing. Yea Email Steve Greg, he is always putting wierd Pics in here, but I like em | Thanks | Richard
Electronics Forum | Fri May 08 16:30:59 EDT 1998 | Chrys
| I am running boards with gold fingers on a pallet for | masking purposes. The pallets worked fine for a while | but know the gold fingers are getting solder on them. We | have tried everythin: new pallets, cleaning the pallet | and board to be s
Electronics Forum | Tue May 19 08:48:05 EDT 1998 | Aric Parr
| | I am running boards with gold fingers on a pallet for | | masking purposes. The pallets worked fine for a while | | but know the gold fingers are getting solder on them. We | | have tried everythin: new pallets, cleaning the pallet | | and boa
Electronics Forum | Tue Jan 06 21:19:05 EST 1998 | Dominic Nguyen
We use no clean paste and sometimes experience flux splattering which gives spot on gold fingers. Need help in analize the cause. thx.
.gif)
