Electronics Forum | Sat Nov 22 18:51:14 EST 2003 | lkavan
So, I have a documentation and service manulal for HS180 now. I checked HPIB addresses, it is all right. But I found, that I cannot edit whole config and machine data. In manual is written, that all datas you can edit during first instalation only. I
Electronics Forum | Mon Jan 23 14:20:32 EST 2006 | gipos
Hi Chunks, Thank you very much for your advise.It is realy helpfull.Seven years of experience are the most precious. But we have already payed the Universal Full IR.We can use it for curring of glue and paint.Do you know where we can find user or se
Electronics Forum | Mon Jun 05 19:08:08 EDT 2017 | zsoden
Thanks for the suggestions, Caurbach. We do have the occasional lead jumping out even at this length, hence why we've been hesitant to cut them shorter. I have the wave nozzle to PCB distance set as per the machine instructions (4mm I think?). I ce
Electronics Forum | Fri Aug 17 11:53:42 EDT 2007 | escalador
Hi Dejan: Glad to hear from you. I will check the soft version as soon as I get a transformer. I tried to register on the Universal page without success.I suspect that I have to buy something...,someone from Universal in Spain contacted me by phone
Electronics Forum | Thu Sep 02 10:50:21 EDT 2010 | eezday
I'm bringing a GSM-1 machine at a university back to operational condition. I have a project created and I'm experiencing that when it's loaded the PWC goes to a location that is about two inches too narrow. When the PWC is manually told to go to a
Electronics Forum | Wed Mar 19 19:19:41 EDT 2014 | dave222
thank you for taking the time to look at this post. hopefully someone can help. I have a GSM2 Q block with a Flexjet 7 spindle head. a couple of days ago the machine encounter this issue while zeroing. the issue is with head 2 on beam 2. on the di
Electronics Forum | Mon Oct 13 15:33:36 EDT 2014 | rgduval
So...today, we were able to get rid of the z axis not mounted error. It looks like we did so by modifying the settings in axes location (matched them to the beam 1 settings). Now, when we try to lower the nozzles, we can hear a relay or switch clic
Electronics Forum | Fri Feb 19 11:13:02 EST 2016 | ttheis
I'm setting up a product for the first time on my GSM after I completed debugging some other issues. The previous owners had the PWC axis disabled and the axis motor disconnected, so I re-connected it and enabled it and now it homes and moves. When I
Electronics Forum | Mon Mar 07 18:23:30 EST 2016 | ttheis
Hi everyone, I'm about 90% to running production on my gsm but I'm not able to get the machine to look at fiducial marks and make corrections to the placement. When I run advanced board configuration and seek to the first fiducial the pec camera tra
Electronics Forum | Tue Mar 12 10:16:05 EDT 2013 | bocci572
Yes the components are flat and no larger than 50mm in size. Most are full rings or just an arc of a ring. I understand fully the best way to have the capabilities proven would be to have the vendor demonstrate. I am kind of looking at what people
