Electronics Forum | Tue Mar 22 11:57:07 EDT 2011 | jercole
Make sure the paper is advancing correctly on > your stencil wiper. I have seen this cause major > issues. If the paper hangs up, it will smear > paste across the bottom of the stencil every time > it wipes. We are manually cleaning the stenci
Electronics Forum | Fri Jan 03 15:16:54 EST 2014 | ppminc
If all of the lights are on, on the operator interface panel usually that means the EPCU is defective or not fully seated correctly. If you swapped out the EPCU board from another machine you need to make sure its the same type of machine. If it has
Electronics Forum | Sat Sep 05 16:09:10 EDT 2015 | emanuel
Need assistance - I want to disconnect an unused LCS module from an Emerald machine. I disabled the tray changer and buffer conveyor in the machine's configuration but I still get an L212 error on the bottom of the screen and the machine hangs during
Electronics Forum | Fri Nov 18 15:45:27 EST 2016 | jg_annaanthan
Hi all, my site using x-ray machine "Agilent 5DX Series 5". The tester will hang around 10- 15 min during perform automatic startup at level "Delta Z". My site, we already change Front & Rear laser, burn galil, performed manual startup, total shutdow
Electronics Forum | Tue May 22 02:21:12 EDT 2018 | robl
Hi Reckless, We've had machines from all over the world off it, just need to keep an eye and move fast. Had quite a bit from USA over the years, also Korea, Scandinavia, Germany. Good deals don't tend to hang around. Rob.
Electronics Forum | Mon Mar 09 16:28:48 EDT 2020 | sportsradar
Hello Sarason, Unfortunately the machine is no longer supported and we are such a small company we can not afford to replace this machine. Thank you for your advise, I will check for additional parts stuck in the machine (long shot but worth the time
Electronics Forum | Mon Mar 09 16:30:42 EDT 2020 | sportsradar
We have the software and our PC has been running the machine for approx 10 years. I just don't know why all of a sudden it decided to have this problem. :( Also I have the software if you think I can reinstall from the diskettes. Will check, and ag
Electronics Forum | Mon Mar 16 14:08:44 EDT 2020 | sportsradar
Thank you for your reply. So the machine should preform a zero set without the line controller being turned ON? I never tried starting the machine first so I am unfamiliar with this. Thank you again. This community is great. Sincerely, Katrina
Electronics Forum | Tue Mar 17 09:09:34 EDT 2020 | emeto
You should be able to operate/troubleshoot machine on its own. Not sure if you have to switch some key on the back to change the mode, or it will initialize on its own using the last program that has been loaded....it's been awhile. Line computer dow
Electronics Forum | Thu Oct 27 13:46:36 EDT 2022 | proceng1
I concur with what Tom said. Sometimes you have to trick the machine. Without seeing your board, I can't offer any specific advice. And I am not familiar with your machine, but we run SAMSUNG machines and between those and several different MPM Pr