Electronics Forum | Wed Dec 28 11:05:27 EST 2022 | atpico
We have 7.2E (MS-DOS variant) software version on our printer and there are some annoying bugs and less than optimal NPI process (when the new board need to be put on and put off the rails several times during NPI teaching). Is there a known newer/be
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Tue Aug 29 15:05:16 EDT 2006 | cyber_wolf
We run a lot of double sided boards. So I need a printer that will handle warped boards well. Can anyone tell me which printers work better on warped boards ? Our AP25's are crap on warped boards. If I had a penny for every time our cameras got kno
Electronics Forum | Thu Sep 07 15:53:09 EDT 2006 | Buzzword Master
I like Buzzwords. My favorite 5 buzzwords: 1. Business-centric 2. Synergy (One of my favorites) 3. Value-added 4. Win-win situation 5. Spatial Standardization I'm also particularly fond of people who make "quote" marks in the air with their fingers
Electronics Forum | Sat Jan 21 10:28:16 EST 2023 | compit
The so-called "drivers" are used to control each servo - control boards at the back of the machine. There are several (8?). If one is "worn out" and has no strength to move the servo, maybe this is where the error comes from? They can be interchanged
Electronics Forum | Thu Sep 07 13:48:58 EDT 2006 | cardinal
Rick, I didn't mean for this to turn into a big thing thing but a couple of points. 1. I have in this business for over ten years. 2. Speedline sells refurbed units for over $75K 3. If you think it is "BS" come to my facility and check it out. 4. I
Electronics Forum | Thu Sep 07 09:04:24 EDT 2006 | Doug Eidle
Hi, First off, I am the Pre Owned Equip. Business Mgr. for Speedline Technologies. We have a factory Renewed (our enhanced refurbishment process) available. You can contact your local Speedline MPM Rep for price and information. If board warp is
Electronics Forum | Mon Jul 29 09:19:00 EDT 2002 | pjc
Quick Change Tooling is one advantage for DEK when comparing the MPM UP2000. DEK has Form Flex. Good system, but I've heard concerns about long term dependabilty. All support tooling options offered on the UP2000 takes a bit of time to set up. So, If
Electronics Forum | Fri Sep 22 08:37:47 EDT 2006 | john
Using MPM UP2000 Hie printer.When give cycle wiper command,After comleting forward stroke machine gives error wiper not parked,press next to continue.If press NEXT VY axis software limit comes and machine give message press NEXT to continue.IF press
Electronics Forum | Fri Sep 01 18:59:40 EDT 2006 | chrisgriffin
Fastek- From the sound of the attitude, you must be competition. And trust me, we do much more than clean them up and paint. How about you? But thanks for the sarcasm. And when you've refurbished a hundred MPM's, you tend to become an expert.