Electronics Forum | Fri Feb 21 18:27:23 EST 2020 | tomdegas
Thanks for the quick response. I’ll try it tomorrow and let you know if that worked. I do grease it but there may be residual older grease still there.
Electronics Forum | Tue Mar 03 14:38:55 EST 2020 | emeto
I don't remember as it has been a while, but this is the board you have to replace.
Electronics Forum | Wed Mar 04 14:32:21 EST 2020 | bk
The mot mi board is the first board but it is two boards tied together so you need to undo the screws on the first 2 boards on the left.
Electronics Forum | Tue May 18 10:35:11 EDT 2021 | kumarb
Hi. See this thread which may help you: https://smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=22839Message85508
Electronics Forum | Thu Dec 28 20:46:49 EST 2023 | padawanlinuxero
I was use to work with the machine but it has being several years since I had one in my hands, but i got the same error message, I kinda remember there are some sensors in the top part of the hydra try to see if theres dirt or something not letting t
Electronics Forum | Mon Apr 06 14:02:05 EDT 2020 | tomdegas
I have tried that Tim and I get the same error message. Originally it would pass in the service menu but when I switched back to TPsys, it would fail. I tested the friction one time it did pass and it was well withing the range. Thanks for the res
Electronics Forum | Wed Jun 27 02:24:28 EDT 2007 | jola
Check the drive belt first for missing tooth or bad tension. If thats ok you might need to change the clutches, they need to be changed every second year or soo. If they are worn out the wire driving the spindle might slip causing this problem. This
Electronics Forum | Mon Apr 06 17:08:30 EDT 2020 | tima
Try swapping XWB board that is on top of X-Wagon. Have you try that? All signals go thru there. Another thing can be those 2 ribbon cables that are behind of X-Wagon. How long ago did you change them? What I would do is to move X to different positio
Electronics Forum | Thu Oct 15 10:21:30 EDT 2015 | azdback
troubleshooting a table lift error on MY12. Error code: F-MOT_Releaseboard conveyor lift/1304. Basically, the table got stuck on the up position. Also bench tested both lift motors and they are ok.Rotated the lift motors manually to test the encoder
Electronics Forum | Mon May 06 14:55:58 EDT 2013 | dyoungquist
We had that problem on our M12. There were a few components that had gotten dropped into the camera area as the hydra head past over it. Our MY12 has a knob towards the front of the machine in direct line with the camera. Pulling this knob release