Electronics Forum | Mon Aug 19 11:36:27 EDT 2019 | bulur
How does no-clean flux residues on a PCB assembly impact the ROSE testing? Does no-clean flux residues on the PCBA dissolve in solution of ROSE tester and increase ionic contaminants level in terms of NaCl per surface area? Is ROSE tester solution (a
Electronics Forum | Mon Aug 19 13:32:54 EDT 2019 | aqueous
ROSE testing a post-reflow assembly which has been reflowed using no-clean flux may not yield information that is helpful. No-clean flux technology works by encapsulating the flux's activators and other chemical constitutes that would be harmful if l
Electronics Forum | Thu Apr 20 08:49:08 EDT 2006 | Chunks
a) Is there a recommended dip or dwell time for the dip soldering? Check your data sheet for the part. Dwell time is everything in selective soldering. Top side wetting is a good process indicator. b) How do we improve the solder coverage in the
Electronics Forum | Thu Jan 18 15:28:10 EST 2007 | CK the Flip
If you are, in fact, running a No-Clean solder paste: Different no-clean solder pastes will leave different types of (benign) residues. If your paste has been qualified from a Bellcore/SIR/Electromigration standpoint, any residues remaining will NO
Electronics Forum | Wed Apr 19 04:41:42 EDT 2006 | ge_lim
Hi I am using selective soldering to dip soldering the connector pins to the PCB and would like to know your experience: a) Is there a recommended dip or dwell time for the dip soldering? b) How do we improve the solder coverage in the TH? c) How t
Electronics Forum | Wed Apr 26 10:21:09 EDT 2006 | slaine
Hi you need to dip long enough for the temperature of the part being soldered to reach about 20 degrees above liquidus of the solder. For the small parts we dip solder we had Sn62 and SAC387 baths set to 250 degrees and this seems to work best for us
Electronics Forum | Tue Sep 25 19:26:39 EDT 2012 | caurbach
So, I just learned that alpaca isn't just a cousin of the llama, it's also a Cu/Ni alloy (imitation silver). Creeped me out at first... When you say "poor filling and no solder", are you referring to wetting problems? Do you have any photos you co
Electronics Forum | Sun Aug 27 11:37:28 EDT 2000 | RJ
If you have another container of flux that is a different batch try that. Dont forget to clear lines of old flux. check spray pattern width. The activators needed may be dead in flux.Since it is sudden my question would be what just changed?
Electronics Forum | Wed Aug 30 23:45:28 EDT 2000 | Ramon I Garcia C
Hi friends; Steve I'm using flux Kester 959, my top temperature is 187 celcius degrees, my e-mail is ramigary@smtnet.com, Travis I'll check the pcb for contamination, but how may I clean the pcb? may I use alcohol? Nance I cleaned the pipes of the
Electronics Forum | Thu Aug 31 14:27:23 EDT 2000 | Travis Slaughter
How to clean a contaminated board would depend on what it�s contaminated by, alcohol may be just the thing. If there is bare copper that has corroded that could be more of a problem, or maybe not if its due to poor tinning by the board house you coul
