Electronics Forum | Thu Aug 01 13:04:57 EDT 2002 | gdstanton
Its interesting. It appears I'm getting conflicting feeback from Indium. This says its not a problem... http://indium.custhelp.com/cgi-bin/indium.cfg/php/enduser/std_adp.php?p_sid=kTDKGClg&p_lva=&p_faqid=355&p_created=1014734692&p_sp=cF9ncmlkc29
Electronics Forum | Tue Sep 30 09:21:08 EDT 2008 | eedlund
Anyone using a No-clean solder paste on a pcb with a 100 Mbps Ethernet chip? Will the residue cause any signal degradation? Any issues with a no-clean solder paste and 1000 Mbps Gigabit Ethernet? Device: National Semiconductor DP83848 10/100 Mb
Electronics Forum | Thu Aug 24 09:23:29 EDT 2000 | Dr. Ning-Cheng Lee
You are asking a very good question which has been an issue in the industry for a long long time. For operating at 225C, you will need a solder with melting point no lower than 270 or even 280C. HMP solder is very difficult to come by. At this stage,
Electronics Forum | Fri Aug 02 12:01:40 EDT 2002 | johnw
interesting, not at all what we were told so yes lot's of contradictions comming from them, I have to say personally I've not beein impressed with there technical service of late, are they getting complacent I ask? it's strange they say it'll cause
Electronics Forum | Tue Sep 30 20:55:14 EDT 2008 | davef
Residues from different no-clean fluxes produce different levels of variation in RF circuits. Some no-clean fluxes work fine. Following this, a no-clean flux can produce different levels of variation in RF circuits depending on the process setup.
Electronics Forum | Fri Apr 23 15:33:50 EDT 1999 | C.K.
| | Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free soldering on t
Electronics Forum | Sun Apr 25 12:05:50 EDT 1999 | Chrys Shea
| | | Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | | | | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free solderin
Electronics Forum | Mon Apr 26 09:18:27 EDT 1999 | C.K.
| | | | Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | | | | | | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free so
Electronics Forum | Wed May 25 18:09:47 EDT 2005 | Fluxed_State_of mind
Need some input here..... The fear is that the if we use water soluble flux at the repair operation, that the no-clean encapsulation will capture some of the organic material as it cools down and goes to its original state. The organic material wil
Electronics Forum | Tue Sep 30 18:06:43 EDT 2008 | realchunks
I would think if the product can take wash, it could take no-clean. Unless it has sensitive devices susceptible to leakage.