Electronics Forum | Wed Jan 28 16:04:43 EST 2004 | kauer
We have been given a factory quote for Nitro upgrade on Omniflow 7s. It sounds like a pretty major undertaking, with a couple of factory Techs on site for a few days to do it. Nothing I would like to jump into blind. Be carefull, Good luck.
Electronics Forum | Tue Feb 10 12:40:32 EST 2004 | neil
Thanks for the comments. There was some problems with the JavaScript fly out menus. The search engine spiders had some issues with it and some users had issues, too (myself included). Nothing but straight links now.
Electronics Forum | Tue Mar 09 13:31:59 EST 2004 | blu_nozer
I suggest you look at the IPC/EIA J-STD-001C. It provides 3 different yardsticks depending on the end use of the equipment. Class 3 became the de facto military standard in Noth America since MIL-STD-2000A was withdrawn. Bob
Electronics Forum | Mon Apr 05 12:30:47 EDT 2004 | russ
Nothing has changed recently with the above mentioned finishes. so the archives will bring you up to date. Russ
Electronics Forum | Tue Apr 27 16:57:13 EDT 2004 | black5629
I have air, It start up and "About to Reset/press next to cont. When I press next nothing happens, if I press anything else "Machine not Reset" comes up. Can the axes be manualy reset? Thanks
Electronics Forum | Mon May 10 01:20:07 EDT 2004 | longpham246
Hello! Check your stopper up/down sensor position. This problem has nothing to do with the proper data. Sometimes the sensor position is not correct or sensor contact could cause this problem even I/O mode was OK. Regards! LMQ
Electronics Forum | Mon May 24 12:01:35 EDT 2004 | Sue PH
Thanks for the reply Russ. I did check the archives before I wrote in. Must have put too many words in cause nothing came up. Found it this time. Lots of good info there. Thanks again
Electronics Forum | Wed Sep 29 08:44:57 EDT 2004 | davef
Nothing to say that you can't purchase thermocouple wire and spot weld it in the machine shop at your local high school.
Electronics Forum | Thu Dec 09 09:56:19 EST 2004 | russ
Indium has some alloys that are very close to this but not exactly. You may want to contact them if nothing shakes loose from here. www.indium.com Russ
Electronics Forum | Thu Dec 23 20:18:01 EST 2004 | davef
Look here: http://www.standardpc.com/hitemp-laminates.htm There is nothing significant in the selection of this supplier's table than others posted on the web.