Electronics Forum | Thu Nov 02 04:42:48 EDT 2023 | tinaheussaff
In general, it is safer to use a single alloy with a known composition and performance characteristics. If you need to change the alloy used in your selective soldering machine bath, it is advisable to consult with the manufacturer or a soldering exp
Electronics Forum | Wed Mar 31 20:49:11 EST 2004 | marcowong
We are trying to buy used double wave solder and ICT machine and we need some advice on selecting the machine and things to be cautious with. It will be greatly appreciated if someone can offer us good suggestions that will help us to minimise mist
Electronics Forum | Tue Oct 18 10:36:46 EDT 2022 | winston_one
Dear proffessionals! Question is about this alloys - Sn99Cu07 and Sn100 (Sn100C,Sn100Ni+ etc.). Is it O'k to mix them? In my case to use Sn99Cu07 as addition to selective soldering machine bath with Sn100C? Main components are the same, but minor add
Electronics Forum | Thu Sep 11 16:50:18 EDT 2003 | davef
Sure it's conceivable that thin HASL can cause tombstoning. Harkening back to the ample discussion in the fine SMTnet Archives, tombstoning is caused by an imbalance in solder surface tension between the two pads of SMT component. The source of thi
Electronics Forum | Fri Mar 27 12:46:23 EDT 2020 | unisoft
Unisoft has been import gerber only for years to setup assembly, aoi machines, etc. *** Help for Importing GERBER only files for used in programming Assembly, AOI, Test, Selective Soldering machines (X/Y Center, Rot, Part#). Also allows you to cre
Electronics Forum | Mon Sep 17 16:03:13 EDT 2001 | jschake
The results from an experiment comparing 27 different combinations of pad dimensions concluded that the pad design with 15 mil pad length, 12 mil pad width, and 9 mil pad separation produced the best assembly yields. A 5 mil thick laser cut stencil
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Wed Jul 05 09:00:13 EDT 2006 | russ
Sounds like possibly too little preheat. Russ
Electronics Forum | Tue Jan 16 07:59:36 EST 2007 | tk380514
we worked out that the wave soldering cassettes Duratstone material takes alomst 35 degree away from the surface of the pcb, and the speed is already too slow it should be over 1.0 - 1.8 meters a minute but its now already 82 cm a minute, in order to