Electronics Forum | Fri Aug 26 09:39:21 EDT 2022 | compit
The emulator doesn't work that way. You can create only 1.44 MB partitions (e.g. 100 pieces on one flash drive) (with the supplied software) and they will be visible as floppy disks. It is not a USB port.
Electronics Forum | Sat Jul 17 15:22:17 EDT 2004 | rohman23
Thanks for all the responses. I do agree with what was said, and can certainly see reasons not to try. I'll write a little more about what we do. We are a defense contractor, and as I mentioned very high mix, low volume. We only have 1 SMT line.
Electronics Forum | Mon Aug 14 01:29:49 EDT 2023 | calebcsmt
I have noticed on a recent project, the QFN and SOP solder deposits do not seem very uniform and have been leaving little balls, whiskers and icicles of solder paste coming from some pads which leads to bridges. https://imgur.com/a/lqw5RF1 I have u
Electronics Forum | Tue Jan 03 03:01:35 EST 2006 | Frank
The 740 and 760 basically have the same specs as far as component ranges: 0402-50mm components. The 760 is a bit more accurate and the vision system is better. The 740 was designed when BGA weren't really around and so it can barely vision center b
Electronics Forum | Tue Aug 23 09:52:51 EDT 2022 | jojoled
Can anybody recomend exact model number of USB to floppy disk emulator, which works for sure on JUKI KE7xx series PnP machines? I have bought this one : https://www.gotekemulator.com/P_view.asp?pid=54 and have KE760 machine, but it doesnt work (tried
Electronics Forum | Tue May 09 01:53:01 EDT 2023 | frankchan
Hey, tried Capital"JUKI" and lower case"juki"
Electronics Forum | Thu Mar 28 15:53:49 EDT 2019 | SMTA-Jon
As a CM, we don’t have a lot of input on the PCB layouts we receive. Some engineers/software packages output the paste layer 1 to 1, some do an across the board reduction, and some set each part up individually with different reductions per footprin
Electronics Forum | Thu Jan 05 15:36:40 EST 2006 | gipos
You are very kind and helpfull. Do you know if Juki still support 700 series with hardware/software? We have bought two pieces of FS730(1997)from big German company.They are said to be in good working condition but you never know, handling in transp
Electronics Forum | Wed Nov 03 16:16:32 EDT 2010 | briansmi1116
I have a Zevatech 720 that was working great until one day a "E9001 the emergency stop button has been pressed..." error popped up when I turned the machine on. We traced out the circuit and found out what board it went to. I found a replacement an
Electronics Forum | Mon May 22 12:44:11 EDT 2017 | emeto
I always would like to go with new equipment compared to used. You will get free technical support with the deal for 2-3 years including parts, repairs, proper training..... If speed and quantity are not the key, there are dozen of small machines out