Electronics Forum | Wed Mar 19 17:18:24 EDT 2014 | aybars
I would suggest to check your servo amps. on both gantries and both axis.Does it rattle both heads or just one? Since you did not specify this in your question,I will say check all 4 servos in the back side of your machine.Hope this will help and goo
Electronics Forum | Thu Jun 12 11:04:48 EDT 2014 | bobpan
You could have a bad hard drive or the bios settings could be incorrect. We also need to find out what motherboard version you have. Please e-mail me for further help. Go to: www.precision-repairs.com and my e-mail address is on the site. Bob
Electronics Forum | Fri Jun 23 12:38:49 EDT 2017 | jamesn
Hello Please can someone help with a feeder Base Issue I get the message " Warning Base Manager 2 Runtime '7e' Error Wrong Message Parameter " I have swapped the removable bases 1 & 2 over but the fault still lies with base manager 2 I will than
Electronics Forum | Mon Jun 26 09:33:07 EDT 2017 | bobpan
So I am assuming that you are using the IQ feeders option on the machine. First thing I would check is to make sure you don't have an older feeder on the machine. There was a certain point where quad feeders would be 'IQ' capable or not. You may have
Electronics Forum | Thu Jun 06 09:03:48 EDT 2019 | bobpan
If the part is 10mm or less as long as you are scanning it near the top...it should work. The other possible problem is dirt on the quadalign lens. Clean off the lens and watch it when it homes....both heads should home the same way. If the head jum
Electronics Forum | Wed Jul 03 06:52:27 EDT 2019 | bobpan
Seems to be fighting to hold its position. 1. Check for anything worn out...possibly idler bearing/pulley and/or the belt. 2. Maybe it could use servo tuning...this may help but usually servo tuning is not that critical. 3. Clean the scale and the
Electronics Forum | Wed Jul 03 08:10:34 EDT 2019 | bobpan
The amp is mounted on the back side and is black. 4 total mounted for x and y axis.....swap the 2 that are y axis amps. If you have never servo tuned before on a quad machine you not going to be able to do it. There is way to many things that you nee
Electronics Forum | Tue Feb 09 10:34:53 EST 2021 | jamesn
Hello Gents I have a problem with the head on gantry 2. I think it needs replacing but in the meantime Can anyone on the forum tell me how to disable it so the machine will initialise and run gantry 1 Ive been told it can be done but they cant rememb
Electronics Forum | Fri Jul 15 08:34:20 EDT 2022 | richardcargill
We've had gear do this due to insufficient cooling/blocked vents etc. Obviously if it's hot where you are right now it'll amplify the effect. Sticking a desk fan next to the electronics to add additional cooling to it will diagnose this simply - if i
Electronics Forum | Thu Jun 03 13:11:02 EDT 2004 | Scott B
We had an existing Mydata MY15 line and inherited 2 Quad lines (QSP2 and QSX1). We eventually had to get rid of the 2 Quads (major software and hardware issues) and have replaced these two machines with an addition single Mydata MY15 and are getting