Electronics Forum | Mon Jan 04 22:59:23 EST 1999 | Kris Ewen
I'd like to add something about the ECD product. During a past work term (I'm a a co-op student) in an SMA plant, I worked extensively with the Super MOLE Gold in developing the reflow profiles for high-mix, low-volume production. I was 'married' t
Electronics Forum | Wed Feb 15 19:20:46 EST 2006 | Mr. Samir
Russ, On both instruments, I ran them through the wave 20 times each using identical profiles and wave parameters, and then used statistical formulas to measure the variation and repeatability of each. I had these all in Excel, but that was around 1
Electronics Forum | Mon Jan 04 11:32:59 EST 1999 | Chrys
| Anyone have any experience with ECD's Waverider/MOLE profiling equipment? If so, were they positive experiences? | I use ECD's mole for profiling in the wave and a KIC for profiling in reflow. I like the KIC a whole lot better for a couple of re
Electronics Forum | Wed Sep 26 11:15:59 EDT 2001 | Hussman
What do you folks use for control on your wave solder process? Primarily after wave. I know there are a variety of "wave riders" that will assure proper wave solder parameters, but would like to know what down stream controls some are using. We ar
Electronics Forum | Mon Dec 03 21:46:04 EST 2001 | davef
GET ANSWER? Shore. Tks t'all. DA DRILL? Naw, never found it. I worked at this plant down in Arkansas, where we cooked dirt. [Got it so hot, it glowed orange.] Virtually everyone in the plant had a wauky taukie. About half of the 2-ways would g
Electronics Forum | Tue May 02 12:17:22 EDT 2000 | C.K.
Donnie is correct. "NO-Clean" doesn't translate to "no-residue!"..... who's giving you hassle about this - your ICT guys??!! Residue remaining on your PCB substrate is a function of many different things - flux deposition, solder mask (glossy means
Electronics Forum | Mon Sep 13 04:37:22 EDT 1999 | Brian
| I noticed that some of our pcb's component legend/designation are unreadable as they are placed under smt pads. Is this correct and according to standard? Although we don't have any problems with them as of now, I would like to know the effects on
Electronics Forum | Mon Sep 13 09:49:16 EDT 1999 | John Thorup
| | I noticed that some of our pcb's component legend/designation are unreadable as they are placed under smt pads. Is this correct and according to standard? Although we don't have any problems with them as of now, I would like to know the effects o
Electronics Forum | Fri Jun 25 09:51:35 EDT 1999 | C.K.
| Dear John/Earl | | Thanks for your clarifications. To me also the problem does not seem to be linked with the PCB. The Pre heater temp. is set at | 450 degree C. We are using Alpha Aq. cleanable flux. Can you elaborate on the Desired profilin
Electronics Forum | Thu Jul 14 16:05:55 EDT 2005 | russ
Good answer slthomas! This has got to be the biggest misconception out there. To perform SPC on a wave process you must first perfrom DOE to determine the critical parameters and or control limits. For example you will need temp reading devices tha