Electronics Forum | Thu Feb 15 16:01:53 EST 2007 | jdengler
Bert, Clean the emitter disk of the nozzle you use for this part. Set everything in the PD back to where it should be and set the "Lead_check_area" to 10. This will look at 10% of the end of the leads. This will help if the leads do not have even
Electronics Forum | Thu Aug 30 11:11:43 EDT 2007 | slthomas
I think you can reach that screen with SH SET command, then do a SET [command name] [value] to change it. Make sure you write down the original values somewhere or do a print screen of your current settings before tweaking them, though.
Electronics Forum | Fri Dec 09 18:35:01 EST 2011 | ngotranbestek
I have Oven Heller 1912EXL. I bought it is used machine ago 6 month Do anybody have experience about it? - How many speed Rail? - How many Zone need set, (10 zone or 11 or 12 zone need set?) - How is 3 cooling zone? need set or no?. ...
Electronics Forum | Fri Sep 14 13:00:28 EDT 2012 | mark25y2001
Try to check encoder if properly locked, also check encoder connector if properley inserted, if all good, it's possible that the conveyor controller or encoder problem... to check controller related just try to set in zero value, then if conveyor are
Electronics Forum | Mon Feb 23 14:58:01 EST 2015 | ercdave1
I found the solution to my problem. Since I don't have a manual for the machine. I had no idea how to change the system settings but by pressing the first 2 buttons on the left of the front panel I got the system settings menu and was able to change
Electronics Forum | Fri Oct 23 10:21:45 EDT 2015 | kurtiss
During production the machine Cycle Alarm ESC 3. When cycling power the error shows up again during a zero set after performing the Z1 zero set. When it errors out on zero set the only option that the machine allows is to power off. Thanks in advance
Electronics Forum | Fri Feb 19 15:23:31 EST 2016 | ttheis
RESOLVED I adjusted the "Minimum Board Width" in the Board Handling Configuration to resolve this issue. I set the lane width to a larger value which did not hit the front limit and measured the difference between the actual lane width and the set l
Electronics Forum | Tue Jan 24 22:43:20 EST 2017 | david_chiu
Absolutely ok!! We already co-use the same profile setting for top and bottom side to avoid line efficiency loss for more than 10 years. But only one thing you should careful is the heavy mechanical parts on bottom side may drop during reflow proces
Electronics Forum | Tue May 22 10:01:19 EDT 2018 | jacson_vu
Hi All, Could you share for me inspection spec that you set up for SPI machine ? Which standard you base that? IPC or something like that. So far, my factory set up as below: Area , volume , high are: lower limit is 60%, upper limit 160% for 0201 ch
Electronics Forum | Mon Jan 27 13:47:44 EST 2020 | dnachristen
The DEK Gridlock system should have rubber pads on top of the metal posts. We had them in our old Dek machines but upgraded to the fully automatic ones on our O3iX machines (Grid Lok) The manual ones can be tricky to set up and requires you to have
.png)
