Electronics Forum | Thu Sep 23 14:58:50 EDT 2004 | C Lampron
EMS-Engineer, Lead free alloys have a very low wetting creep. You probably will not ever get the same type of weting with a LF as opposed to SN 63/37. The question is if it is acceptable. Lead free solder joints cannot be inspected to the same crite
Electronics Forum | Thu Mar 23 22:26:53 EST 2006 | Joseph
Dear all, Referring comment from Mr. Jack,IPC director certification & assembly technology, the term "fillet tearing" is too broad. Cracks or fractures in the required fillet area, with SnPb or LF alloy and whether you call it tearing or not, is a D
Electronics Forum | Wed Mar 22 01:24:54 EST 2006 | Joseph
Dear all, Referring technical report from Vitronics Soltec, "Pad lifting, fillet lifting and fillet tearing issues in LF soldering". The use of LF solder alloys today has brought about a recurrence of this crack formation, called fillet tearing. The
Electronics Forum | Sun Aug 08 11:15:32 EDT 1999 | Earl Moon
| | Mike, | | | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no goo
Electronics Forum | Wed Oct 20 14:24:32 EDT 2004 | Steve Gregory
It all depends where the voids are, and that's tough to do with a transmission x-ray. One needs to be able tilt the assembly at 45-degrees during x-ray, so you can get an idea where the void is. Or, you spend some big bucks for an x-ray laminography
Electronics Forum | Wed Oct 20 14:44:24 EDT 2004 | Steve Gregory
It all depends where the voids are, and that's tough to do with a transmission x-ray. One needs to be able tilt the assembly at 45-degrees during x-ray, so you can get an idea where the void is. Or, you spend some big bucks for an x-ray laminography
Electronics Forum | Wed Feb 02 21:56:11 EST 2005 | davef
Based on X-ray imaging, IPC-7095 standard specifies three categories for void size for BGA solder joints. These categories are based on the percentage of joint cross sectional area occupied by the voided area. Class III Small: Void area is LT 9% Cla
Electronics Forum | Thu Aug 09 09:05:09 EDT 2007 | davef
There are no requirements acceptance criteria for baking of board assemblies. What are your customer requirements? The common reasons people choose to bake PCB are to prevent: * Delamination of multilayer boards * Measles, particularly on double si
Electronics Forum | Tue Mar 26 23:26:35 EST 2002 | ianchan
Hi Guys, (Note: We are not talking about bill-board RES/CAP, we are talking about Z-axis slant/tilted RES/CAP with respect to the PCB pad Z-axis plane). 1) We ref through the IPC-A-610C specification "bible", and can not find a "chapter/verse" tha
Electronics Forum | Wed Jan 23 01:24:45 EST 2008 | dragonslong
Hi ppl, i just joined my company as a quality engineer and was revising our incoming visual inspection. I was reading the IPC guidelines of IPC-7095. However, i have some problems which i hope the experts from this forum could help. IPC-7095: At on
IPC is the trade association for the printed wiring board and electronics assembly industries.
Training Provider / Events Organizer / Association / Non-Profit
3000 Lakeside Drive, 309 S
Bannockburn, IL USA
Phone: 847-615-7100
.gif)
