Electronics Forum | Wed Jun 27 11:59:55 EDT 2007 | samir
*Preheat zone *Maximum slope is a time/temperature relationship that measures how fast the temperature on the printed circuit board changes. The ramp�up rate is usually somewhere between 1.0 �C and 3.0 �C per second, often falling between 2.0 �C and
Electronics Forum | Tue Jun 02 22:19:17 EDT 2009 | mikehe
We have been doing BGA's for years now, and I would suggest updating your profile and place a thermal couple on the BGA, keep in mind the bigger the part the more heat it will need, We stencil print all of BGA's from simple bga's to complex ones, you
Electronics Forum | Fri Oct 10 20:56:50 EDT 2014 | jlawson
Main issues... Pad Design Thermal Mismatch Design related to pads effected Moisture and out gassing in substrate / part terminations can move parts slightly during preheat prior to liquidous this get position shift ( smaller the parts more an issue)
Electronics Forum | Wed May 28 08:25:08 EDT 2003 | davef
That's what we do [no more than three reworks or mods]. Your "four reworks permissable" was probably based on the 55110 five thermal cycles, counting wave soldering as the first cycle. How do you plan to keep track of each of those rework actions?
Electronics Forum | Thu Apr 05 08:44:45 EDT 2007 | ck_the_flip
"Guest" is right, actually. CSP's are essentially BGA's, but typically the pitch and ball diameters are much smaller and in some cases, the pads of the CSP's can not be screen printed. If that's the case, you'd have to have flux-dip capabilities on
Electronics Forum | Thu Oct 01 07:09:53 EDT 2009 | g2garyg2
Good Morning Here are a few thoughts. When mfg large flex circuits you will need to fixture them to create a stable production environment. As such, the foot print fo the product grows. So you may require systems that can handle 20 inch width by 38 i
Electronics Forum | Tue Mar 04 07:23:15 EST 2003 | msivigny
Hello ricardof, To implement Cpk studies on SMT production equipment, you will require highly accurate glass plates, glass component slugs, accurately manufactured stencils and a measurement system to perform X, Y and Theta positional deviations from
Electronics Forum | Thu Jun 04 12:22:12 EDT 1998 | John Allan
| | | Hello: | | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold jo
Electronics Forum | Thu Aug 10 12:14:12 EDT 2000 | Charles
It looks like a giant dpak device but with 5 leads. The problem is that on approx 3% of our boards one more pins are open circuit. It appears that the pins are not in contact with the pads. Board is HASL finish IR oven Paste Koki 953i. If you have a
Electronics Forum | Sat Apr 25 19:40:01 EDT 1998 | Stan Traxler
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components We have appl
