Electronics Forum | Tue Jun 22 13:37:56 EDT 1999 | Jason Gregory
| I am need of info regarding the tape cutter blades for a Sanyo/Universal 4760 HSP chipshooter. Ours are gone and beyond repair. I have found that the blades are the same as on the 4765 HSP. Part nos. are | | UPPER-6300056280 | LOWER-6300056273 |
Electronics Forum | Thu Jun 16 18:23:52 EDT 2005 | Jason Fullerton
Check your pick height/depth. Check your feeder alignment. We run 0402s at 0.10 tact. We run 0201s at 0.20 tact, but only because I don't require any more throughput - I have placed them at 0.10 during testing, and there are companies that place th
Electronics Forum | Tue Jun 21 08:20:26 EDT 2005 | vickt
Verifying pick height is a good start. Are you using the proper nozzle (81) and feeder (yellow)? How was the comp lib created? If you continue to have any problems, I would suggest copying an 0402 from the master library. You can also call UIC's tech
Electronics Forum | Wed Jun 08 09:31:35 EDT 2005 | PWH
We have an HSP 4796B chipshooter on the floor. Feeder pick-ups after changeover (during new run start-up) are always a bit of a hastle. Can anyone tell me if a feeder "zeroing" jig works well? I always reset feeder B offsets. I recorded "B" offse
Electronics Forum | Mon Feb 26 16:16:41 EST 2001 | bcaler
Wanted, Universal's part number for a 201 nozzle used on the HSP4796. Just the part number for one nozzle please. Or contact me if you have one you can sell me. Thanks, Brian
Electronics Forum | Tue Sep 16 09:29:19 EDT 2003 | Graeme
Jan When you fit these new unit drivers check to see if the software level is the same as what is in the remaining unit drivers, as if it is not you will find that there is a steady failure of other exsisting unit drivers.If the software level in the
Electronics Forum | Wed Nov 10 06:32:20 EST 1999 | Lee Radney
We lost the video on a touchscreen monitor that goes in in our HSP 4791 machine. The touchscreen still works but the monitor portion is dead. The monitor is a Mitsubishi Model number XC-1498C II... The Microtouch numbers are as follows....Model #
Electronics Forum | Fri Oct 24 09:03:34 EDT 2003 | Bill
Has anybody had to replace the rear LCD monitor on a 4796 HSP chipshooter? Universal is quoting 10k (!) for a new one as they are hard to locate. Patlite (the LCD manufacturer) has discontinued the unit GSC-1000ARS-W and is unable to help. If an
Electronics Forum | Thu Jan 25 15:52:07 EST 2007 | electrovert
What is your budget? Hsp 4796 from Universal is great. You can still use Hsp4790 feeders with the Hsp 4796. Hsp4796 is very durable and it is can self taught a component. This is very helpful for you since you do a lot of prototype. Universal (Gsm) h
Electronics Forum | Wed Feb 02 16:29:43 EST 2011 | remullis
I can explain our kitting process which was heavily software managed. For our Chipshooters we grouped setups of the optimum algorithym for less carriage movement, and grouping part numbers as much as possible. This was done with some high dollar sof