Electronics Forum | Sat Apr 26 08:18:47 EDT 2008 | davef
Your warpage problem could be caused by change in: * Multilayer board construction (not homogeneous or unbalanced - too resin rich or poor) * Supplier process capabilities (lamination cycles) * Material selections (usually cheap and dirty), etc.
Electronics Forum | Fri Jan 29 04:39:31 EST 2016 | thaneshsivanadian
Due to the imbalance of copper distribution between top and bottom side of PCB, may cause war-page after reflow?
Electronics Forum | Wed Aug 17 17:17:45 EDT 2016 | davef
Warpage of a completed assembly is an uncommon requirement. I would ask whoever is laying that requirement on you to define how they would like you to measure it.
Electronics Forum | Thu Apr 07 20:16:23 EDT 2005 | davef
Q1) Simple way to measure the PCB warpage A1) IPC-TM-650; Method 2.4.22 Bow & Twist Q2) What is the maximum warpage can the SMT machine allow the to accept and place the component without problem. A2) That depends. IPC-A-610 Acceptability of Elect
Electronics Forum | Thu Jul 22 05:00:45 EDT 1999 | George Verboven
| I have pcb's in which i am experiencing warping. | the boards are 12.8125" on a diagonal measurement. | they are out approximatley .010". | the boards are combination thru-hole,smt, they also have 3ounce copper.what is acceptable,and what is the pr
Electronics Forum | Fri Apr 08 05:10:10 EDT 2005 | siverts
What is Your customers requirements? Is the PCBA mounted with front/back connectors? Will the PCBA be mounded in a rack and connected to opposite connectors on the other side? In this case, if the warpage is more than approx 1-1.5 % You will then n
Electronics Forum | Thu Jun 08 22:54:31 EDT 2006 | hunghung
Dear all, If a PCB board, 2 mils of core with 1oz copper at the top and bottom, is it a good board to be fabricated? will it be caused warpage during etching for inner layer process? if yes, what is the real factor caused to warpage? How to solve t
Electronics Forum | Tue Feb 15 14:02:04 EST 2005 | DasonC
Ken, can U share your video information for the SBGA warpage? Thank
Electronics Forum | Fri Nov 08 05:40:54 EST 2019 | leeg
We place these on a few boards and have no issues with reflow or warpage. How thick is your PCB?