Electronics Forum | Wed Mar 22 03:00:09 EST 2006 | meritajs
Hi All, We have problem with Zevatech FS-730 This machine shows error E202062: "System error: T axis of head: Parameter error when T axis performs PTP action.(Kind of unit)" and it stop running. It does not pick up components. At low speed it works s
Electronics Forum | Fri Jun 01 10:33:49 EDT 2012 | cbeneat
Tried fluxing, then letting it sit for an hour and then running it through post fluxer...no bridging, only tried one board though, we're pretty busy at the wave so I have to slide things in between jobs. Also cutting the leads down also worked, but
Electronics Forum | Wed Nov 10 18:06:40 EST 2010 | rodrigo
Hi all... I have the F4g connected to a CP65 and I can transmit programs and receive proper data without a problem. So I was reading the manual and it says that I can use the Real Time Monitor to monitor ... stuff. I don't knnow how this works! I st
Electronics Forum | Tue Aug 24 16:06:09 EDT 2004 | Robert Ack
Being a surface mount department manager for well over 6 years I have seen this countless times. While we run mostly water soluble I havent seen any negative issues while running boards through the oven twice. Sometimes we even spray an additional am
Electronics Forum | Wed Dec 14 12:57:23 EST 2005 | grantp
Hi, Wow, that's cheap. I did not know they were available that low cost, and we had been quoted much higher for the Ursa scope, so that's why I thought why bother, and lets put it into xray. I bet Superman would have a terrible time working in an S
Electronics Forum | Tue Jun 24 11:58:55 EDT 2014 | markhoch
We had both a MY15 and a TP11 both with tray wagons and we taped strips to the tray wagon all the time with great success. we used double sided tape, sometimes with magnets, and then created "trays" as if the tape strip was a matrix tray. (1 x 10,15
Electronics Forum | Fri Mar 24 08:44:08 EST 2006 | Mark
I have used tooling holes, connector holes, via holes, and others. As long as the hole is consistent than it should not be a problem. I have never tried a pad for a fiducial before because of the paste being on it and thought it would not work. So ma
Electronics Forum | Wed Oct 25 10:42:07 EDT 2000 | slowe
We currently have the first version of formflex and had nothing but problems with the pins sticking. Dek now has a new version which is supposed to have eliminated the sticky pin problem. These will be replacing the first generation formflex. Until w
Electronics Forum | Fri May 19 10:08:47 EDT 2017 | majorelectronics
We want to make use of BOM Connector software from Router Solutions. Does your company work with this software? Please let me know how does this software works for your company. Is it a big time saver compared to your other system you worked with to
Electronics Forum | Tue Sep 15 13:02:55 EDT 2009 | horvath83
What do you think about optimal setup for 8-hour working shift and 16-hour standby time. What is the most energy efficient setup for standby time? Complete cooldown or maintaining temperature in solder pot?
