Electronics Forum | Wed Mar 03 13:51:54 EST 1999 | Dave F
| We are a small division. We are starting up a leadless line with an old screen printer and a convection oven. At this time we don't intend to get any sort of pick and place assistance and wil be loading by hand. We find the biggest problem with
Electronics Forum | Wed May 15 22:23:38 EDT 2002 | ianchan
Hi mates, need some help to resolve a thumb-twine situation. As a high-mix, low volume prototype build house, we always conduct a first article inspection (FAI) on every model setup conversion in the SMT production Lot run. we do this FAI by mounti
Electronics Forum | Mon Sep 17 06:11:41 EDT 2012 | kq702
Hi I did a reflow on a laptop board and after the reflow the board is warped in the area I did the reflow in, and now the laptop screen does not turn on at all when I put it back into the laptop. Original problem was the wifi (I did the reflow more o
Electronics Forum | Fri Feb 13 11:22:17 EST 2015 | slarochellesmt
I can offer some background on the IINEO II as I feel it is much better than the Yamaha. I currently have 3 IINEO IIs in production that replaced 3 Assembleon lines. The IINEOs handle quick changeovers better than any SMT line that I have used to d
Electronics Forum | Thu May 03 22:51:14 EDT 2007 | jmelson
I am still learning the CSM84, but have gotten one board programmed and working. Now, I'm doing the next board, and need to use the mechanical alignment unit for a 22 x 22 mm TQFP. This chip is too large to clear the jaws on any head. Can the CSM h
Electronics Forum | Wed Feb 26 21:38:08 EST 2003 | jonfox
1. First and foremost is paste alignment. If you start out of the gates with a bad paste/pad relationship, it will be nothing but problems down the line. AOI is not required, but dial in the alignment, QC if necessary, then introduce the boards to
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Thu Dec 14 04:02:40 EST 2017 | spoiltforchoice
"I would expect that any intelligent feeder > enabled machine would pull the correct part no > matter where it is placed on the machine (not > forced by the program)" > > this is true, but you > have to tradeoff the setup time vs production > t
Electronics Forum | Thu Mar 15 18:15:28 EDT 2018 | maustin
The 740 has been a great machine for us. We've been able to reliably load components as small as 0603 (we've not tried 0402, but I believe with a special nozzle adaptor, you can get it to work) and place a 7x7 56 pin QFN with 0.4mm pin pitch with hi
Electronics Forum | Thu Oct 29 16:22:42 EDT 2020 | spoiltforchoice
The software is crazy expensive for some of this stuff and in many cases you could develop the bits of it you actually use in-house for a fraction of the cost. Unless you are a company who really like this level of process control and you run multip
