Electronics Forum | Thu Mar 25 16:10:31 EST 1999 | Chrys Shea
| I have not been good at this and I assume others have not either, so I figure I'll mouth-off about it, even though I'm probably the only jerk on SMTnet that doesn't visit SMTnet Banner Advertisers. | | I believe that we need to visit SMTnet Banne
Electronics Forum | Mon Mar 29 07:08:59 EST 1999 | Wayne Bracy
| | I have not been good at this and I assume others have not either, so I figure I'll mouth-off about it, even though I'm probably the only jerk on SMTnet that doesn't visit SMTnet Banner Advertisers. | | | | I believe that we need to visit SMTnet
Electronics Forum | Thu Mar 25 19:19:08 EST 1999 | Graham Naisbitt
| I am looking into replacing another business division's Acrylic coating process with our Urethane coating process. Unfortunately, MIL-I-46068 doesn't differentiate AR/UR's performance, and the MFR data sheets don't match up at all (they each spec
Electronics Forum | Fri Mar 26 13:02:18 EST 1999 | Scott McKee
Sorry, in the following message I'm agreeing with Graham - not Greg... | | I am looking into replacing another business division's Acrylic coating process with our Urethane coating process. Unfortunately, MIL-I-46068 doesn't differentiate AR/UR's p
Electronics Forum | Tue Mar 23 14:45:59 EST 1999 | Russell Bartley
| I WORK FOR A SMALL TO MID-SIZE CONTRACT ASSEMBLY HOUSE. WE ARE TRYING TO FIND ANY SURVEYS OR STUDIES DONE ON THE USE OF BGA'S BY COMPANIES ON NEW DESIGNS. THE WAY EVERYBODY'S ALWAYS TALKING ABOUT BGA'S YOU WOULD THINK THAT THERE WILL BE NOTHING E
Electronics Forum | Tue Mar 30 22:35:52 EST 1999 | dean
| I WORK FOR A SMALL TO MID-SIZE CONTRACT ASSEMBLY HOUSE. WE ARE TRYING TO FIND ANY SURVEYS OR STUDIES DONE ON THE USE OF BGA'S BY COMPANIES ON NEW DESIGNS. THE WAY EVERYBODY'S ALWAYS TALKING ABOUT BGA'S YOU WOULD THINK THAT THERE WILL BE NOTHING E
Electronics Forum | Tue Mar 23 04:07:44 EST 1999 | Scott Davies
Rob, We are also using intrusive reflow to simultaneously process SMT and Thru-hole components. Our arrangement goes as follows: - Screen print solder paste to the single sided PCB using 0.008" laser cut stencil. - Apply adhesive dots to selected
Electronics Forum | Thu Mar 25 14:00:45 EST 1999 | Bob Willis
| Rob, | | We are also using intrusive reflow to simultaneously process SMT and Thru-hole components. Our arrangement goes as follows: | | - Screen print solder paste to the single sided PCB using 0.008" laser cut stencil. | - Apply adhesive dots
Electronics Forum | Tue Mar 23 02:32:23 EST 1999 | Bob Willis
| | Has any one seen failures of chip resistors after 1-2 years where the junction between the silver termination and the restive element on the top of the ceramic has corroded through. This results in a high resistance failure after this period of t
Electronics Forum | Wed Mar 24 02:23:14 EST 1999 | P.L. Sorenson - Technical Consultant
| | | Has any one seen failures of chip resistors after 1-2 years where the junction between the silver termination and the restive element on the top of the ceramic has corroded through. This results in a high resistance failure after this period of
