Electronics Forum | Wed Jun 17 08:28:59 EDT 1998 | Dave F
| | Ben: Why not consider some of the training suggestions made by SMTNeter's to Marcos on the tread shown below? Dave F | | Looking for Training in SMT process - Marcos Silva 15:24:13 6/12/98 (7) | Dave- I did happen to look over those posts befor
Electronics Forum | Sat Jun 13 07:08:46 EDT 1998 | Dave F
| Is their an IPC standard for the water that is being used in the water wash. I have been looking and at this time have not found any thing. Steve: A lot of the old command and control specification environment has changed with the "industrializati
Electronics Forum | Thu Apr 30 16:35:51 EDT 1998 | Earl Moon
To our dearest Cunli (maybe not dearest to us all), You have provided us with a vehicle to do SMT and PCB's right the first time, on time, every time, at the lowest cost while meeting customer quality and reliability requirements we say is necessar
Electronics Forum | Wed Oct 03 17:07:52 EDT 2001 | davef
We have had soldering problems with fine pitch QFP in the past [and probably will in the future]. Several questions leap to mind: * When you took your profile on the component pads, do you profile on the pads that did not solder well? * When you say
Electronics Forum | Wed Oct 24 18:10:56 EDT 2001 | davef
We attended several presentations on AOI machines at a recent SMTA meeting. The presenters gave a section about process verification. They bantied about numbers. [I want to say 350 DPMO, but we glaze over when it gets to that stuff] So, you might
Electronics Forum | Wed Oct 24 18:09:44 EDT 2001 | davef
Allowing the board fabricator to define the board you expect to receive is fine, as long as they do a good job. Regardless of the existence of a clear product definition or not, it�s reasonable for you to argue that your receipts must meet the requi
Electronics Forum | Mon Nov 12 16:14:47 EST 2001 | davef
Yes!!! How can we assemble boards with 20 pitch when we allow 0.008� error to the master art? Excellent question!!! IPC-D-300G has nothing to do with assembler requirements. It is written by and for fabricators, so that they can be comfortable.
Electronics Forum | Wed Jan 16 20:08:48 EST 2002 | davef
Comments are: * Some people use calibrated boards and components to remove sources of variation when using their CMM to measure placement accuracy. Sources of supply are listed in the fine SMTnet Archives. * It�s unclear that a single board will mee
Electronics Forum | Fri Feb 22 13:54:40 EST 2002 | seand
Hello Armin, If you are putting a matrix together to determine the best equipment set to use then a good path would be to start with your product and production expectations. Is this to be utilized strictly for typical SMT products? Are there any
Electronics Forum | Sun Apr 14 14:35:39 EDT 2002 | davef
Average people get on stage and sing cover songs in karaoke. But for other people, people in the karaoke circuit, it's a money sport. As with other bar sports (ie, pool, darts, horse, etc), the karaoke-for-money game is rife with hustlers. * "In 'D