Electronics Forum | Fri Nov 22 00:09:29 EST 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem. 1. after hardware initiation appear - F-MOT-MOVE X/250: Motor speed out of control (photo1). 2. in service mode when x motor initiate appear - F-MOT-MSETDYN X/12: No axis movemen
Electronics Forum | Mon Nov 25 10:57:31 EST 2019 | rgduval
You should be able to see the counts in the service screen for the motors while testing them...that's usually the easiest way to see if they're functioning...at least the encoders. In some of the older systems, the drive motors were all the same, an
Electronics Forum | Fri Nov 22 16:19:45 EST 2019 | davef
I'd guess ... + Pads have no solder mask, clear or otherwise. + Pads won't take solder, because you're trying to solder to nickel. + Nickel on the pads is oxidized and is sticking out its tongue at the flux you're using. + Something went south
Electronics Forum | Wed Dec 18 12:37:37 EST 2019 | kylehunter
> I worked at a similar sized facility in Texas, > and we had everything connected to one vent and > exhausted outside. A word of advice; Your outside > vent will leak in heavy rain, don't put it over > any equipment. Ahh yeah t
Electronics Forum | Sat Dec 21 15:08:11 EST 2019 | stephendo
You can use one but over spec it. It will be a non-linear problem to figure out how much each exhaust port exhausts. Also have lots of shut off valves to shut off exhaust ports that you are not using. We have some holes in the walls in the back of th
Electronics Forum | Thu Dec 26 17:21:18 EST 2019 | rgduval
If you're going to vent through a single exhaust/fan combo, I would recommend spending the money, and getting an HVAC company in there to size the exhaust fan, and duct work. It'll pay dividends for you in the future. We did that at a previous comp
Electronics Forum | Mon Jan 06 05:53:47 EST 2020 | richardcargill
First switch on after the holidays and this year it's the Dek265 playing up. On switch on, the screen comes up with "motor comms failure, card 0 axis123 " . On looking at the cards there seems to be a power feed missing ( see attached pict
Electronics Forum | Thu Jan 16 10:07:12 EST 2020 | davef
Hej back at ya Your connectors could be warping during reflow. Find out by putting a connector on a hot plate and increasing the temperature. If so, you might get away with a simple fix of rotating the board 90* on your reflow oven conveyor. If you
Electronics Forum | Wed Jan 29 18:31:06 EST 2020 | slthomas
The 4 places I've worked in SMT all had their own solutions for their own reason. I quit worrying about what worked best if what I had worked OK. I've only seen (or recognized, at least) tension issues on foils that had been saved well beyond a rea
Electronics Forum | Wed Feb 26 11:31:42 EST 2020 | philc
I use a stereo microscope (Mantis) and find it way better for soldering/rework than a camera system, which we also have here. The camera system does NOT give you the same 3D-type of image that the Mantis does, BUT, there are times when you are inspec
