Electronics Forum | Mon Mar 28 18:05:13 EST 2005 | darby
The Yamaha manual is pretty straight forward on this one so I presume the "Philips" is as well. Go to the Maintenance, Repair and Adjustment chapter and look up Drift-Adjusting. It is in the Controller section. If you don't have a manual let us know
Electronics Forum | Mon Mar 28 09:56:36 EST 2005 | n wolford
We have a granite table out on our production floor. We use the table along with metal parallel bars and a height gauge to measure component height. Some of these boards have components on them that may be ESD sensitive. Does anyone have experience w
Electronics Forum | Tue Mar 29 13:14:28 EST 2005 | bobpan
Anyone familiar with making smema work on the ekra x5. I believe is was manufactured with a siemens (not smema)setup. We found the cables to make the siemens work but i am not sure if i can short a couple of inputs on the cable to make the smema func
Electronics Forum | Thu Mar 31 19:52:50 EST 2005 | davef
We agree with Russ that you're talking palladium instead of platinum. Your wetting problem likely is not the Pd-Ag surface layers, but the underlying metal or nickel to which you need to wet. Either a base metal is: * Contaminated and poorly wettabl
Electronics Forum | Fri Apr 08 12:03:31 EDT 2005 | mmjm_1099
Here we go again..... check all past forums on Lead-Free. There is a TON of stuff that people has talked and commented on for this. Plus a good site for alot of information I found is: http://www.speedlinetech.com/news_publications/white-papers.aspx
Electronics Forum | Fri Apr 15 11:16:03 EDT 2005 | HOSS
It's a longshot but.....I have seen low-standoff parts move caused by via's under the part erupting from within internal layers (outgassing). If this is a multilayer PCB and vias are not well plated or pourus, they can and will expand when heated.
Electronics Forum | Tue May 03 20:57:37 EDT 2005 | smtuser1234
None taken...but if you are comparing Mydata and Assembleon to Universal just because of ease of use you should probably not buy Universal. It's like buying a palm pilot vs a desktop computer. Close in price but one will do a lot more but you will ne
Electronics Forum | Tue May 03 12:28:45 EDT 2005 | jh0n!
I hate to start to drag this off-topic, but I just had someone here interject that perhaps going to 20x20 and using a different adaptor would be the way we should go, due to the cost difference. Can you (or anyone) quickly identify a few reasons why
Electronics Forum | Wed May 18 03:13:28 EDT 2005 | grantp
Hi, We place BGA, but until now have not used X-Ray inspection, and it would be a good thing to have. Can anyone recommend a low cost X-Ray that would get us by. We don't need something fast, but it should be able to show us clearly voids etc. Reg
Electronics Forum | Thu May 19 17:03:11 EDT 2005 | splice1
Hi all, There are no ground layers which makes the non wetting rate a bit confounding. The foam fluxer has not been cleaned in a while though, while there is a strong evidence of fluxing by running blank paper and looking up the top side