Electronics Forum | Thu Dec 20 10:23:12 EST 2007 | slthomas
You could have said "why don't you just flop 'em over twice into the right tray?" lol. Yeah, that's the right way. I was kind of focused on what I had to do here to get two different parts from full trays into two cut-in-half-the-long-way trays sinc
Electronics Forum | Wed Dec 19 22:48:40 EST 2007 | davef
Naw, your legend is cured epoxy that's not going anywhere. There's no magic solution that will correct the mess you've made [found yourself in]. Use a sharp xacto-like knife to scape the legend off. People should have noticed and corrected this bef
Electronics Forum | Tue May 19 09:13:45 EDT 2009 | cyber_wolf
The loaders/carriers work well on CP643's in my opinion. We have had ours for about 4 years. However, if you crash them it can be a beeoch to get everything back into proper function. We have very little issue as long as we have our techs do rail wi
Electronics Forum | Fri Jan 11 16:33:59 EST 2008 | mgershenson
We have 30 years of soldernig experience, 25 years in soldering robotics, and have had laser based systems for a few years now. I'm not sure you need a laser for this application. It's really going to depend on whether or not an iron tip can get in
Electronics Forum | Mon Jan 14 19:07:29 EST 2008 | swag
Your IC's should run great. I have changed out a handful of cameras inside the box (you know when your camera is burning out because the monitor will show black/gray horizontal lines). It's pretty easy. Aftermarket cameras are about $350 I believe
Electronics Forum | Mon Jan 21 12:06:47 EST 2008 | sliebl
As others have said, Bliss racks are not cheap, but they sure are nice. We are a small single shift shop, but we have 4 of their carts. Two for stencils and two for feeders. Even fully loaded these roll very nicely if you need to get them out of the
Electronics Forum | Sun Feb 03 11:10:13 EST 2008 | fastek
Pretty simple explanation really as it's happened to equipment I have sold and sent to Asia. If the paperwork on the importer's side of the transaction isn't up to snuff or they haven't paid off the right guy to get it in the country, the machine w
Electronics Forum | Mon Feb 04 14:42:08 EST 2008 | ratsalad
Are you talking about Durastone? That's what we use for our wave pallets. Both our wave vendor and solder bar vendor told us that we had nothing to worry about as far as Pb-contamination of the pallets. We have used the same pallets across our Sn
Electronics Forum | Wed Jan 30 12:35:41 EST 2008 | patrickbruneel
I agree with Fastek. If we (the consumer) go shopping do we care more about the country of manufacturing than the pricetag? My family does but too many times they come to me and say �sorry we couldn�t find anything made in USA� only designed in USA
Electronics Forum | Mon Feb 04 10:38:14 EST 2008 | slthomas
Sure looks like flux residue to me and I don't know how your bare boards could be causing that unless there's something on them when you get them, and that you would notice. I'd still be looking at my own system, blowers and exhaust lines. Do any of