Electronics Forum | Fri Feb 05 09:39:58 EST 1999 | Dave F
| Can anyone help me with the pros and cons of trying to wave | solder tantalum and large (1812) ceramic capacitors. I do | know that one may see fractures on larger cermaic caps, but have not seen much on the tantalums. Any insight as to what proble
Electronics Forum | Wed Jan 27 19:42:34 EST 1999 | parag palshikar
i am working with the noclean process and getting white residues on the bottomside of the board probably due to the wave soldering flux.i am using a no-clean solder paste and a noclean wave solder flux.The boards passed the accelerated temperature a
Electronics Forum | Thu Jan 28 08:42:43 EST 1999 | Dave F
| i am working with the noclean process and getting white residues on the bottomside of the board probably due to the | wave soldering flux.i am using a no-clean solder paste and a noclean wave solder flux.The boards passed the accelerated temperatu
Electronics Forum | Wed Oct 07 17:36:48 EDT 1998 | Ted Nicholas
Hello! Does any one know of a disadvantage of using the Phillips recommended wave solder SOIC footprint where the last pad on each side of the SOIC is enlarged, instead of placing an extra pair of pads behind the SOIC. Both footprint patterns seem e
Electronics Forum | Fri Aug 28 13:20:45 EDT 1998 | Justin Medernach
| What approach do you you use to reducing wave solder dross? What is your experience with Klennox? | Dave F Dave, I use Kleenox on my Air-Vac Volcanic Soldering pots. The stuff works great. It significantly reduces the amount of dross you remove
Electronics Forum | Wed Jul 08 15:18:20 EDT 1998 | Upinder Singh
We are wave soldering a board having 24 similar thru hole connectors on it, using a wave soldering pallet. The problem is that one particular pin of connector in around 6-9 connectors get excess solder on the bottom side. I have tried all the parame
Electronics Forum | Thu Jul 09 17:12:00 EDT 1998 | Dave F
| We are wave soldering a board having 24 similar thru hole connectors on it, using a wave soldering pallet. The problem is that one particular pin of connector in around 6-9 connectors get excess solder on the bottom side. I have tried all the par
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
Electronics Forum | Sun Jun 07 06:05:37 EDT 1998 | Bob Willis
| Can anyone tell me if there is a reference for smt component height specs on the bottom side of a board, which will also go through wave soldering. A current design I am reviewing has tant caps(7343) and a crystal on the back side. Should I only b
Electronics Forum | Sat May 09 11:46:43 EDT 1998 | Bob Willis
The first thing is all the TSOP suppliers like Intel do not rate the parts at normal temperature used in wave soldering. The spec is less than 230C so you have the reliability issue to consider and no one to blame when they do not work. You also have