Electronics Forum | Mon May 04 09:18:18 EDT 2020 | ilavu
Also, Check jumpers on 9pin connectors at front, rear and both side. If anyone missing or broken, will do the same.
Electronics Forum | Wed May 06 09:24:07 EDT 2020 | tomazicrok3
hello does anyone know why i cant get out of freeze mode on samsung cp40cv machine when i press emerg. key. greetings
Electronics Forum | Thu May 07 01:09:02 EDT 2020 | kylehunter
We've definitely changed our bare board source. Now are using a mix of USA based and South Korean. Helps to have some extra options..
Electronics Forum | Fri May 08 20:29:09 EDT 2020 | gregoireg
I don't want to steal this thread so I have posted mine (in case a Mexico company read this...) https://smtnet.com/Forums/index.cfm?Thread_ID=22654
Electronics Forum | Wed Oct 21 00:40:09 EDT 2020 | gabriel1blue
Any of you need it to replace the floppy drives for these machines? I want to upgrade it to something better but having problems getting it done. Thank you guys for all your help. Gabriel
Electronics Forum | Mon Jun 08 09:20:57 EDT 2020 | vinitverma
Since it is an Emerald XII, I suppose it is Windows and not VIOS. Go to Optimize and select "Convert with Note Data". This will convert all blocks to single PCB and keep a NOTE of original Block Data so that you can convert back to block if and when
Electronics Forum | Mon Jun 08 16:57:09 EDT 2020 | joost
yes! this is what i was looking for, i figured it out today with the help of Michal who gave my 2 manuals. thank you very much for you're respond's. for the order that i just ran it gave me over 10% faster runspeed
Electronics Forum | Wed May 27 09:03:24 EDT 2020 | bobpan
The motherboard bios settings are incorrect. For me to help you please email me. My email address is on my website. www.precision-repairs.com Thanks, Bob
Electronics Forum | Mon Jun 08 09:22:10 EDT 2020 | vinitverma
I guess the link you sent shows Top Side of the component. Send a picture of the bottom side - which the camera will see and I may be able to help.
Electronics Forum | Tue Jun 09 16:29:03 EDT 2020 | dilogic
Since rear feeder bank can be in three different positions, machine must know which one it is. Check in Machine Setup, Parameters - Feeders (see attached image). It that's set wrong, machine will try to reach position out of range and will hit end sw