Electronics Forum | Tue Mar 14 09:54:34 EST 2006 | slthomas
"45* is a common angle of attack. Squeegee blades are commonly manufactured at 60*. The combination of the angle of attack and the blade angle results in an actual printing angle between the two due to down pressure and flex of the blade." Ahhhh, so
Electronics Forum | Tue Mar 14 14:25:15 EST 2006 | geb
Hi, I have a 1995 Universal GSM which won't zero its axis, so can't run. It crashed last night after displaying a "swapper.dat" file being full. I have restarted and checked the available space on the hard-drive - it has over 50% freespace. After st
Electronics Forum | Thu Apr 06 15:35:04 EDT 2006 | jbrower
Larry, Are you a glutton for punishment, a masochist, just so sure that your answers are right and or important, or are you just REALLYYY bored at work and decided to be a dumb ass on the forums.. Loading boards into a flow solder machine for 12 ye
Electronics Forum | Thu Mar 30 12:48:54 EST 2006 | krc
Pardon my ignorance on this subject but I gotta ask... When the SMT guys load partial reels, I'm told that they have to waste a few components in the process. It seemed obvious to me that there should be a kind of tape that can be added to the end
Electronics Forum | Thu Jun 08 19:51:22 EDT 2006 | grantp
Hi, That's good news, and we did outs with SN100C as well on Wed, however we are still working hard on getting a good profile. We have some large BNC connectors, and they are hard to profile. We also have wave palettes, and these might be too thick
Electronics Forum | Wed Jul 05 16:01:53 EDT 2006 | Chunks
I agree with Grant. The MYDATA machines we had were very easy to program, adjust and as Grant states make them pick up from just about anything. The best part of them was using partial reels or strips of parts. These machine don't care about havin
Electronics Forum | Thu Jul 20 05:04:30 EDT 2006 | bing007
We had a similar problem with gold contact pads. Cleanliness is paramount. If you are using foil tensioning system, wash the foil in a stencil wash before use as the cardboard cassettes may be contaminated. Be very careful when loading into a frame f
Electronics Forum | Tue Jul 18 15:47:07 EDT 2006 | Mark
IPC610 training to help verify issues that might arise. Also, the opeators need to know part numbers and descriptions because that should be common knowledge when running a SMT line. Plus, with your comment "At our company they know how the pick&plac
Electronics Forum | Fri Aug 11 12:45:10 EDT 2006 | mpm fan
It's been awhile but isn't there a sensor to tell the middle conveyor when it is lined up with the incoming and outgoing rails? If so that would explain why the table goes into Z axis overtravel. It still means your Y isn't working but makes it less
Electronics Forum | Thu Aug 17 17:03:00 EDT 2006 | markb
Steve - The weakened condition was my concern, and that was why I was asking if anyone had any details on issues that may occur doing this. Do you know of any details behind the risks involved? Qualifying a new LED will take a load of R&D resourc