Electronics Forum | Fri Feb 16 09:16:19 EST 2007 | John S.
We conducted a DOE to establish our print setup parameters. These will of course depend on the paste you select, and the thing just runs. The techs store the head in a ziplock bag when not in use. When they need to run, they just attach the head,
Electronics Forum | Thu Feb 22 18:28:28 EST 2007 | Cmiller
You could probably put a 1/4" plate of steel over the aluminum and make some shorter magnet pins. I think the factory upgrade was $3500 to $4500. Its hard to justify the cost based on saving maybe 5 minutes a set-up for an operator. But your lines wi
Electronics Forum | Mon Mar 05 07:59:11 EST 2007 | jdengler
Mark, I will begin by saying I am a big fan of Fuji equipment so I would not recommend anything else if you already know them. You say you get 70K placements a month with these 2 lines? Do you mean 70K boards a month? The first place to look a
Electronics Forum | Tue Mar 20 21:49:38 EDT 2007 | davef
Mark there is no need to YELL here. Turn it down, please. While you're waiting for other to reply, search the fine SMTnet Archives to find threads like: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=34512 You'll find that the followi
Electronics Forum | Tue Mar 27 06:15:54 EDT 2007 | CL
Good Morning, We have 5 My machines. We process 0402's daily and have not seen any accuracy issues. We are also processing 0201's, 01005's (although not often thank God!), Micro BGA's, CSP's, etc... Definately not the fastest machines but very flex
Electronics Forum | Wed Apr 25 08:40:45 EDT 2007 | avalancher
I've also found that mechanical feeders require much more maintenance than the 'smart' magazines do. Also remember that 'smart' magazines also give you the opportunity to change the setup quickly if necessary, and swap feeders if all can't fit on th
Electronics Forum | Mon May 07 11:09:49 EDT 2007 | davef
4 Fluxer Operation 4.1 Set-Up and Check-Out the Fluxer 4.1.1 Spray Fluxer Set-Up and Check-Out 4.1.1.1 Pass a sample unsoldered board through the machine. 4.1.1.2 Remove the board just after passing through the fluxer and the air knife. 4.1.1.3
Electronics Forum | Thu May 10 19:22:06 EDT 2007 | joeherz
We have a board that requires a .015 - .035" finished lead length which requires us to do mass lead trimming. To this point we've performed this activity on parts with straight leads. We're looking at going to an axial auto-insertion process (outso
Electronics Forum | Thu May 24 12:56:31 EDT 2007 | adlsmt
Im sure you will get some better responses but here is a start. We went from UP2000 to UP3000 Ultraflex about 2 years ago. The UP-2000 uses tooling nests and UP-3000 Ultraflex does not. Makes a huge difference in setup time. Up-3000 is BIG. I think t
Electronics Forum | Tue Jun 05 10:49:31 EDT 2007 | realchunks
Hi WRIGHT, When you the standard, I assume you are talking about what kind of set-ups. If so, then RDR is right. Contact a supplier. Most sell the water and also units that can make D.I. water. It depends on your need and size of your cleaner.