Electronics Forum | Fri Sep 25 08:30:54 EDT 2020 | SMTA-64386317
Normally, on X-Ray will conduct attribute GR&R which measure capability of operators to judge defect and not on equipment itself.
Electronics Forum | Tue Sep 01 10:19:17 EDT 2020 | leeg
We still have a lot of parts supplied in stick format for one reason or another and had some old MBF feeders which work great, does anyone know an alternative aside from the vibratory type feeder?
Electronics Forum | Wed Sep 02 04:08:10 EDT 2020 | bangir
Dear All, Please help to share me Part List for MIRTEC In-Line AOI Machine Model MV-5SE. Thank you for your prompt reply
Electronics Forum | Wed Sep 02 16:59:31 EDT 2020 | emeto
It doesn't seem clear what you really need. Do you have the default libraries from Mirtec with geometrical shapes/Models?
Electronics Forum | Thu Sep 03 02:37:05 EDT 2020 | bangir
We don't have. We want to order spare parts, Looking for the Part Number. The machine have damage on the mirror. Please help
Electronics Forum | Mon Sep 14 18:40:39 EDT 2020 | dwl
A reflow oven with Center rail support can help. If your volumes are too low to justify spending $$ on a proper carrier, titanium stiffeners applied to the PCB before it goes into reflow is a cheap, albeit manual solution.
Electronics Forum | Thu Sep 10 19:26:24 EDT 2020 | emeto
Are parts always following the same side/direction of tombstone? 1. Run 180 and observe if tombstone moves or remains the same 2. Too much paste under the part - reduce aperture and move it out to the lead. 3. Soak profile for even heat distribution
Electronics Forum | Fri Sep 11 01:01:08 EDT 2020 | rsatmech
Thanks for your response. Yes Tombstone is happening in same direction only. We can't rotate every board since the issue is random and the defect rate is around 0.1% Already using high soak profile. Stencil modification in progress.
Electronics Forum | Fri Sep 11 15:20:53 EDT 2020 | rsatmech
Yes it's 0201. Homeplate design is not recommended. Simple going to reduce the aperture size. Just planning to reduce it in both the pad cornor. What's your recommendation.
Electronics Forum | Sat Sep 12 01:30:39 EDT 2020 | rsatmech
Thanks for the information. Much appreciated. We are using 79um thickness stencil. I will share the inputs to my stencil manufacturer.