Electronics Forum | Mon Aug 29 16:31:44 EDT 2022 | aurash
Hi There, Does anyone out there have the specifications for the old stick feeders from JUKI? I'm interested in sizes for SO8 chips. I bought two SFN3 feeders but they seem the wrong size for so8 Thanks in advance Aurash
Electronics Forum | Wed Aug 31 07:23:42 EDT 2022 | leeg
We also use MBF feeders, sadly the belts perish and you can no longer purchase the original belts
Electronics Forum | Wed Aug 31 11:23:39 EDT 2022 | stephendo
I don't know Juki but I know stick feeding SO8 ICs. If you have a lot of them regularly then consider getting a tape and reel machine.
Electronics Forum | Wed Sep 14 18:14:08 EDT 2022 | proceng1
I have not. I did watch an online webinar but of course it showed all the extra stuff that I have no use for. So I pretty much lost interest.
Electronics Forum | Sun Sep 18 08:28:13 EDT 2022 | dilogic
You can swap the board between machines, it's located on the front, down right (VME rack), where all "smart" stuff is locaated.
Electronics Forum | Fri Sep 23 16:42:59 EDT 2022 | kurtiss
It is a 2011 XPRT5 with Software version ESP001-413 2010-08-04.0. The chassis appears to be the same as an X4.
Electronics Forum | Thu Sep 29 20:08:17 EDT 2022 | proy
I have an 8130 Magazine loader (end of line boards into magazines) Has anyone here converted one of these to SUPPLY boards FROM the magazine to the printer/conveyor?
Electronics Forum | Sat Oct 08 20:53:41 EDT 2022 | kumarb
Hi. Which Ekra model? I recall some funky registry keys being installed and we migrated our mechanical drive to a SSD but used a bit copier for the drives (Windows XP) which worked for us. Also, some calibrated data that will be machine specific.
Electronics Forum | Tue Oct 18 11:08:51 EDT 2022 | proceng1
Yes, HANWHA is who to contact. We use TOLP to run 4 lines. Contact jess.ha@hanwha.com
Electronics Forum | Wed Nov 23 19:08:20 EST 2022 | leeg
You should be able to check the sensor, most had have the red light to indicate that a PCB is being detected. Depending on the version of software it should tell you within the manual control option too