Electronics Forum | Thu Oct 23 10:59:58 EDT 2008 | leemeyer
I am running Autoprogram ver. 5.31 and need to split a large program so that it can run on 2 seperate Quad 4C assemblers. When I generate the program I select the "Breakup Program for Seperate Central Controllers" box but I do not get 2 seperate prog
Electronics Forum | Wed Mar 11 13:18:32 EDT 2009 | smellew
Even if you disable the MTU(see address 1005 to link out E-stop & address 1219 for the safety fence rear) the servo still needs to be replaced. SA6 is the faulty one, i'm sure there are many dealers who could supply you one. if you need further conf
Electronics Forum | Fri Mar 13 16:23:10 EDT 2009 | rodrigo
We're going to swap SA-4 and 6 but it is going to take a few days. Thanks for all the help. Follow up: We swapped SA-7 and SA6 (because SA-4 was different). The problem stayed with the original amp. so we're looking for a replacement. Our buyer is h
Electronics Forum | Wed May 20 17:56:51 EDT 2009 | dyoungquist
I have attached a pdf showing the dimensions for the QFN we placed. First, The pins on the part are not only on the bottom side but also wrap around to come up each of the 4 sides of the part as shown in the side view in the attached pdf. This i
Electronics Forum | Mon Jun 01 18:44:54 EDT 2009 | scunneen
Hello there, I have a new board, fairly heavily populated with a number of FPBGA on it. The smallest has a pitch of .4mm.I have 3 questions, 1st what is the best appeture for this small pitch. 2 Will type 3 paste work or will I need type 4, and fina
Electronics Forum | Wed Apr 21 14:38:30 EDT 2010 | remullis
Newer Universal Conveyors use 4 wire smema and FUJI should accomodate this protocol in its config screens. Old Universal Conveyors and some machines used SMPI (forget how many wires), You can purchase the 4 wire smema cable from UIC and conversio
Electronics Forum | Tue Jun 22 00:09:14 EDT 2010 | leadthree
You should do some testing what temp you really get. Solder will melt 260~300ºC. Back to the initial question, CEM-3 is a bit harder to buy and has not many varieties. Go for FR4, you can go for a higher Tg then the common 130ºC. There is also 140,
Electronics Forum | Sat May 29 14:03:18 EDT 2010 | padawanlinuxero
Hello guys! I have a problem I had to change the MI Board on a MYDATA TP9-4 machine because it was firing 3 or more feeders at the same time, after the change it run great but then for some reason after a while it start to show an error message that
Electronics Forum | Tue Jul 13 13:37:23 EDT 2010 | pjc
That's cold compared with this specification from a leading oven mfr.: Flow Rate - 1.0 - 3.0 US gal/min (3.79 - 11.4 l/ min) • Inlet size and pressure - 0.5 in. male NPT; 310 - 483 kPA (45 - 70 psi) • Pressure drop - 200 kPa @ 11.4 l/min (30 psi @ 3
Electronics Forum | Thu Sep 02 16:55:31 EDT 2010 | markgray
I ment LF318. We have a power supply board that has 3 different types of these LGA's and i have had great success with the reductions and stencil thickness mentioned. We had to go with 4 mil stencil due to the consideration of the other large compone
