Electronics Forum | Wed Feb 26 10:54:18 EST 2014 | JB
Hello. Does anyone know how to add a different package to the Part Group on the Samsung CP45FV neo software? See picture. For example if we wanted a heading for Inductors, how do we add that? Thanks
Electronics Forum | Fri May 23 11:14:15 EDT 2014 | rboguski
Agree with previous comment regarding possible head-in-pillow. Use 3D x-ray or CT-scan to verify.
Electronics Forum | Thu Aug 07 12:58:59 EDT 2014 | kahrpr
One of the things you need to know are the parts you are building Flight Critical. Meaning if the board fails will it bring down the aircraft. Or non critical meaning one of the over head light will fail as an example this determines how much latitud
Electronics Forum | Mon Aug 25 16:05:40 EDT 2014 | tombstonesmt
Not familiar with the L series but I'm sure you can have it configured with tray elevator. Not sure about your question regarding the head error.
Electronics Forum | Tue Oct 14 09:22:51 EDT 2014 | rgduval
Deni, Do you know if the theta axis controlled by the same slots/cards as the z-axis, by any chance? We also can't get theta to work on head 2, so, I'm wondering if the issue is related... thanks, ..rob
Electronics Forum | Mon Oct 20 14:56:51 EDT 2014 | rgduval
Progress!! Somehow, this morning I was able to get things almost working. I swapped cards 1 and 2 back, and then back again, so, in the same state as my last reply...set the default settings for the axes configuration...then, verified the addresses
Electronics Forum | Wed Oct 29 18:08:35 EDT 2014 | tombstonesmt
Good afternoon. Not sure if this is available at an engineer level. Perhaps and SD card with field service access is necessary. We have two lines with NPM-W's and the most we've been able to do is actuate vacuum on the heads during flow checks.
Electronics Forum | Fri Nov 14 14:27:02 EST 2014 | proy
Thanks for the comments, I will take the rocks out of my head, throw in a little lead from my ___ and save some $ on solder........... Seriously, will look into some of these ideas, or some iron weights/slabs from metal store P
Electronics Forum | Tue Jun 09 04:49:12 EDT 2015 | vinitverma
Is the machine not picking up nozzle from the nozzle changer or is the head 7 not picking up any components? Or is the mis-pick rate too high?
Electronics Forum | Mon Aug 29 11:39:23 EDT 2016 | tdemon69
I was wondering if you could help me with my Panasonic MV. it is throwing parts around after it picks them up . only have 3 heads work in it.