Electronics Forum | Tue Jun 15 11:08:02 EDT 2004 | russ
Well take away the easy answers! How are the parts falling off? Is the joint breaking the termination on the part or is it breaking at the solder to termination interface? Also, how long are these parts in liquidous state? and what type of paste a
Electronics Forum | Mon Jun 28 22:49:08 EDT 2004 | davef
Look here: http://www.checksum.com/mdatest.html We have no relationship, nor receive benefit from the company linked above.
Electronics Forum | Fri Jun 18 12:51:58 EDT 2004 | JD
Just curious if anyone has had any problems because of using acetone to clean flux off boards or parts. Is acetone an acceptable flux remover for re-work? What are the pros and cons about using acetone Thanks in advance, JD
Electronics Forum | Wed Jun 23 12:27:47 EDT 2004 | Cal
We are interested. contact me off line cal cal driscoll CTDI.com cdriscoll@ctdi.com
Electronics Forum | Sat Jul 03 22:47:35 EDT 2004 | KEN
Steve, the web will not do your needs justice. I would suggest reading everything you can get your hands on. There is much to be learned that has already been published...and even more that has not. There are so many trade-offs with surface finish
Electronics Forum | Fri Jul 02 11:17:09 EDT 2004 | jdumont
I agree, the flux will probably burn off before it gets to do its job. Def not a good idea....
Electronics Forum | Fri Jul 23 18:08:30 EDT 2004 | carterhoward
Hey Marcin, We currently run Philips equipment. We are quit happy with Philips, good change over times, and good software, excellent off line programming I would also recommend contact systems their user interface is one of the best I�ve seen. car
Electronics Forum | Tue Jul 27 07:18:44 EDT 2004 | Nippy
How does the HASL finish and stencil match ? I have seen ocasions on fine pitch devices where the HASL can protrude into the stencil aperture either pulling paste down on the snap off or completely blocking the aperture and getting no paste.
Electronics Forum | Tue Jul 27 11:56:42 EDT 2004 | mmjm_1099
I am looking for a way to get netlisting off of gerbers for prob testing. If anyone knows a program or something we can do to get the numbers let me know via email or post here. Thanks
Electronics Forum | Sun Aug 01 11:27:40 EDT 2004 | haran
What is the best epoxy attachment method for Heat Sink?The operator always miss the solvent dispensing application prior to epoxy dispense which cause the heatsink falling off at customer site as well as in the factory?Any advise?
