Electronics Forum | Tue Mar 12 09:23:52 EDT 2013 | bobpan
If you edit the sequence on the hht.....to fix your problems...you then have to upload the data to central controller. If you are not doing this....you are overwriting the data on the machine with bad data everytime you download to the machine. The l
Electronics Forum | Tue Mar 12 09:24:47 EDT 2013 | bobpan
If you edit the sequence on the hht.....to fix your problems...you then have to upload the data to central controller. If you are not doing this....you are overwriting the data on the machine with bad data everytime you download to the machine. The l
Electronics Forum | Thu Mar 14 07:22:22 EDT 2013 | fredcalkins
This problem has become a real issue with the tacky silicon used in many LEDs. Cree has recomended that the pull off angle be changed for the cover film as mentioned by the previous commentor. With these new silicon LEDs they are recomending teflon o
Electronics Forum | Wed Mar 13 19:56:34 EDT 2013 | hegemon
It has been some time since I programmed a mirtec machine, but I think the technique would be to break the component into different banks of leads with unique locations. U25_Top, U25_Right, U25_LEft, etc... Use the centroid location to check presence
Electronics Forum | Fri Mar 22 12:11:56 EDT 2013 | emeto
Hi, I will focus on the flux one more time. Try different amount(usually more flux should give you better result). Also depends what kind of flux you are using? Water based or alchohol based? Try with another type that you are using. Check the spee
Electronics Forum | Mon Apr 01 17:20:45 EDT 2013 | davef
In thinking about troubleshooting tombstoning {TS} defects, seek balance: * Pads the same size * Same amount of paste on each pad * Component placed with the same amount of contact on each pad * Heating the same on each pad, no via connection to a gr
Electronics Forum | Mon Apr 01 13:47:38 EDT 2013 | microaide
Anyone know how to use AutoProgram 5.32 for the Quad IVc assemblers? I am having all kinds of problems. I can't create a new SMD Type because the Edit menu is greyed out, so I can't select New. I can't figure out how to set up feeders and assign feed
Electronics Forum | Fri Apr 05 14:17:11 EDT 2013 | leemeyer
I have no idea why this limitation would be programmed in. Like I said before there a lot of wierd quirks whith this software and you may have just found one. Pre-assigning will not help if the software sees a mismatch between the feeder plate and th
Electronics Forum | Mon Apr 08 13:09:48 EDT 2013 | microaide
I have set Maximum Sequence Steps Per Program Segment to 450 and Maximum Placements Per Program Segment to 200. I have two Quad IVc machines, with a separate central controller in each one. One machine has a waffle feeder and will have vibratory feed
Electronics Forum | Thu Apr 11 07:45:44 EDT 2013 | leemeyer
I have never run across that error message before. Does the machine have Upward vision? Does this message only occur when trying to run programs that were generated by Autoprogram ? I think that I would create a new program with only 1 component, a r