Electronics Forum | Wed Nov 24 16:08:09 EST 2004 | Terrapin Station
This depends on the model. Most machines and turret style typically overstroke .2mm with a force of 250 - 300 grams of force. the reason for the over stroke is to place the component into the paste. This can be adjusted through part library manipul
Electronics Forum | Fri Dec 31 03:04:24 EST 2004 | Colin G
0805 is 80 thou by 50 thou. As there are 40 thou per mm, this is therefore a device which is 2mm by 1.25mm, i.e., a 2125 Cheers, Colin...
Electronics Forum | Thu May 13 01:14:37 EDT 2004 | vincent
hi, i have a question relating to fiducial, is the fiducial normally comes with the pick and place data from the custommer or we have to define it by ourself? how to set its coordinate so that the cp6 and ip3 (using Fujicam software) will be able to
Electronics Forum | Tue Apr 28 21:48:50 EDT 2009 | davef
Confirm the source of the issue. Run a coalescence test on both lots of paste. A simple coalescence test can quickly determine the condition of solder paste after prolonged use. Simply print a small disk [around 4-5mm diameter and 0.2mm thick - a bu
Electronics Forum | Tue Jul 13 10:31:16 EDT 2004 | davef
No, experience, but a couple of comments are: * Your 2mm leads are proabably not ment to be trimmed. Consider returning these and buying components with shorter leads. [We know, we know. You have to build this piece of junk right NOW!!!! B-)] * I
Electronics Forum | Sun Jan 18 09:20:26 EST 2009 | davef
We're not sure of the condition of your solder paste. So, afte 24 hours, if it's: * Unused, in a reclosed container, maybe a week of life depending on the environment * Used, scrap A simple coalescence test can quickly determine the condition of sol
Electronics Forum | Thu May 13 10:43:34 EDT 2004 | rob_thomas
hi, i have a question relating to fiducial, is > the fiducial normally comes with the pick and > place data from the custommer or we have to > define it by ourself? how to set its coordinate > so that the cp6 and ip3 (using Fujicam software) > w