Electronics Forum | Sun Mar 31 22:50:28 EST 2002 | ianchan
Nope, we do not have solder beads, like we said, what we have are near perfect solder fillets except for the portion where the component is "floating OFF" the pcb pads. We are now mucking through the IPC-A-610C for specifications dictation on "tilted
Electronics Forum | Wed Oct 06 03:18:01 EDT 2004 | Joseph
Dear all, Recently our customer complaint that some components being came off from the pcba after dropping test.But the curious is, the leads show visible solder fillet covering more than 75% of termination area on pad, which is acceptable as per IP
Electronics Forum | Wed Mar 27 19:26:53 EST 2002 | ianchan
After a whole night's self review, I think we can term the slant/tilt as "floating 0805, yet end-terminals have acceptable solder joint formation". the width portion of the 0805 RES/CAP is (floating)elevated from the PCB pad, yet both (width) termin
Electronics Forum | Tue Jul 02 02:50:55 EDT 2002 | ianchan
Hi mates, was going thru the IPC-A-610C Standards, and noted BGA voids stands somewhere between 10%-25% voids permissible in the solder "ball" bump, after reflow process. Was wondering, hypothetical case study, is there any specification for voids
Electronics Forum | Wed Feb 26 17:05:42 EST 2003 | davef
Q1: Are the markings on resistors the actual value? A1: Generally, resistor marking indicates the value of the device, where the first two digits are the value and the third digit is the multiplier. Q2: Do AOI machines look for these markings or do
Electronics Forum | Thu Mar 15 03:24:48 EST 2001 | Scott B
We are currently having a conflict of opinion with our QA department regarding the very few occurences we have of chip resistors being soldered upside down (i.e. the resistive element towards the board). IPC-A-610C para 12.3.2 specifies that this co
Electronics Forum | Thu May 23 03:10:43 EDT 2002 | ianchan
Hi mates, need your advise here. we have solderballs on a model due to neglect by stubborn folks to follow issued process control instructions. the post-reflow PCBA has solderballs stuck in the NC flux residue and is not in compliance to IPC-A-610
Electronics Forum | Mon Oct 28 18:59:25 EST 2002 | tkenny007
Specs for Bow and Twist for PCBs (IPC-A-610C, 10.6. There may be an update by now). I also have a note in our quality guide referencing (IPC-TM-650, 2.4.22) and (MIL-STD-105D). In summary, a PCB should not bow more than 0.040" with all four corner
Electronics Forum | Mon Apr 10 22:32:14 EDT 2000 | Dave F
Mark: If you're looking for a baseline document for judging the acceptability of: * Mechanical assembly * Component installation * Soldering * Cleanliness * Marking * Coating * Laminate condition * Discrete wiring * Surface mounting of components .
Electronics Forum | Thu Mar 15 08:16:28 EST 2001 | davef
In a similar conversation ... Alex Krstic, NovAtel Inc. said ... Hello all. We recently received some boards with some of the chip resistors placed with their resistive elements towards the board. J-STD-001B and C view this as violation for both Cl
