Electronics Forum | Sun Apr 16 14:37:25 EDT 2000 | Roberto Navarro
Hi, I work for Nortel and here rework BGA'S we use DRS22 rework station and CRT 2000 X-ray inspection. The main problem is put again the BGA on the PCB because you need reboling the PCB and you could damage the soldermask. Talking about Air-vac is ve
Electronics Forum | Tue May 11 12:02:03 EDT 1999 | Tony
| We are currently looking at purchasing some BGA rework equipment. Could someone give us the pro's and cons of IR heating (top/bottom)vs. hot air convection ? | All other tips are also welcome. | | Thanks | Philip, I have been doing BGA rework for
Electronics Forum | Fri Apr 09 07:47:51 EDT 2010 | jdengler
Hi John, Our ERSA rework station came with a soldering iron that has a few special tips. We normally do not have a stencil and use tacky flux, so I use the concave tip to prep the pads. This leaves solder on the pads but with a little practice you
Electronics Forum | Sat Jun 05 13:38:22 EDT 2021 | ppcbs
For Linear Tech LGA's we solder bump the LGA using a .30mm solder ball then reflow with a tacky flux. This will provide a void free solder joint and adds a little height to the solder joint in case you use a flux that you want to clean from under th
Electronics Forum | Thu May 13 12:41:10 EDT 1999 | Eric
| | We are currently looking at purchasing some BGA rework equipment. Could someone give us the pro's and cons of IR heating (top/bottom)vs. hot air convection ? | | All other tips are also welcome. | | | | Thanks | | | Philip, | I have been doing
Electronics Forum | Wed May 19 10:48:40 EDT 1999 | Glenn Robertson
| | | We are currently looking at purchasing some BGA rework equipment. Could someone give us the pro's and cons of IR heating (top/bottom)vs. hot air convection ? | | | All other tips are also welcome. | | | | | | Thanks | | | | | Philip, | | I ha
Electronics Forum | Tue Aug 25 08:14:55 EDT 2009 | davef
Among the best BGA rework systems are: * SRT http://www.vjelectronix.com/vjebeta/products.asp?title=Rework%20Solutions * AirVac http://www.air-vac-eng.com * Metcal http://www.metcal.com * ERSA http://www.ersa.de/en
Electronics Forum | Tue Jan 26 00:21:29 EST 1999 | Parvez Patel
Ya I agree with Dean. We've done quite a lot of work with the SRT Summit2000 rework station.The results have been satisfactory, to say the least. One should however characterize the different operating parameters:namely the working scavenger air flow
Electronics Forum | Wed Jan 06 23:49:48 EST 1999 | Chris G.
| Hey All you Einsteins out there!! | | I gotta' problem...('course you do Steve, or you wouldn't be bugging the TechNet now would you?) I had a phone call from a acquaintance of mine wanting to bring two prototype boards over to rework a BGA socket
Electronics Forum | Tue Mar 16 21:28:57 EDT 2010 | davesss
Looking for a manual for this equipment, any help will be appreciated thanks