Electronics Forum | Wed Aug 28 10:16:12 EDT 2002 | Jim M.
Sam We install a lot of die in the SMT room using same process as SMT parts.Water soluble solder paste is used for attachment of die to ceramic and boards. Biggest problem i found is the adjustment from installing the die in the bonding area. The t
Electronics Forum | Fri May 07 18:01:11 EDT 1999 | Bill Schreiber
Just a note about cleaning SMD adhesives. Cleaning does not need to be hazardous. Smart Sonic has a non hazardous process that has been used for over 9 years using a non hazardous detergent that has been certified by the AQMD as a clean air chemist
Electronics Forum | Fri May 07 18:02:37 EDT 1999 | Bill Schreiber
Just a note about cleaning SMD adhesives. Cleaning does not need to be hazardous. Smart Sonic has a non hazardous process that has been used for over 9 years using a non hazardous detergent that has been certified by the AQMD as a clean air chemist
Electronics Forum | Sun Aug 08 04:36:02 EDT 1999 | Brian
Dave Frankly, I think you may be barking up the wrong tree. Like DaveF, I suggest that the process would be horrendously expensive with masking and so on. The $64,000 question is whether what you propose will serve any useful purpose. I venture to
Electronics Forum | Tue Sep 22 12:25:31 EDT 1998 | Chrys
| | Hi Jacqueline! | | Do these joints that you're having problems with happen to be on fine pitch solder joints? Are the fillets staying attached to the foot and separating from the pads cleanly? | | If that is true, are there many vias concen
Electronics Forum | Mon Jul 17 13:37:35 EDT 2006 | carln
Here is something I copied from Circuitnet.com. This appears to answer your question and then some... http://www.circuitnet.com/experts/ Ask the Experts Jul 17, 2006 What type of cleaner method is preferred for lead-free stencils? What type of s
Electronics Forum | Fri May 26 04:58:19 EDT 2023 | auriga2001
I agree with the two other replies. Left alone, it is a defect. If it's just excess adhesive or coating, you can use IPC-7711/7721 'Rework, Modification and Repair of Electronic Assemblies' for guidance on removing. Section 2.3.1 explains how to te
Electronics Forum | Wed Sep 25 15:58:36 EDT 2002 | bschreiber
Hello Dave, I hope that electronic slap didn�t hurt too much. Robf, I am sorry that you did not agree with my initial response, but the answer is very detailed and most of the support material I have is only in paper format so I need to either snai
Electronics Forum | Wed Mar 29 09:31:28 EST 2000 | Erick
Marc: My experience found reliability IS a function of operator skill and attension to the process. Expecially for some RF assemblies. I worked with an engineer from Rogers to develope a process for reworking Pads for a special material. (I thing
Electronics Forum | Wed May 05 23:26:29 EDT 1999 | Dean
| OK, my manager read an article on printing glue (aaargghh!)and wants to know why we aren't doing it. We currently use Fuji GLs and GDMs to dispense glue. I've never done it, but have seen it done at NEPCON and other shows. It looks OK, BUT what