Electronics Forum | Tue Feb 01 16:56:46 EST 2022 | rstellema
Hello all, I have a couple of old FUJI CP-6 SMT placement machines that are operating with very old PCMCIA Flash Memory cards. I would like to insure that I have back-ups should the memory cards fail. I assume that I would need a support USB reader/w
Electronics Forum | Wed May 03 08:43:51 EDT 2006 | Mark Fick
I have a DEK 265 with error code: motor comms failure.card 0, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 0 and still get the same error.I have tried to load the mint program but I cannot get program to abort
Electronics Forum | Mon Feb 08 16:12:36 EST 1999 | Leonard Levy
Has anyone had any experience in using SMT to mount an organic (FR-4, Getek) rider card onto an organic (FR-4, Getek) mother board? By SMT I mean the attachment of the rider card would be through pads directly to pads on the mother board. Thanks,
Electronics Forum | Wed Sep 10 06:31:32 EDT 2003 | qp1
Dear We have several 4796HSP in production We often have problems with the driver card D2332, S-ver1.32 Wver0.11 For replacement they are quite expensive Can someone tell me how to avoid this problem or how to repair these cards Or is this a known p
Electronics Forum | Wed Feb 08 03:07:25 EST 2006 | Ajay SHarma India
Sir i have a question on Backing of Cards. pls. clarify me that Why we always do backing of cards(90 dC for 1hr. in a Oven) for the reflow process before printing the solder paste on the board. and same for the Curing process we are not backing the
Electronics Forum | Sat Jul 19 19:23:48 EDT 2008 | proy
We got it working; We replaced the old video card with an older ISA video card to get the display to work. Then we removed the ELO touchpanel ISA card, which cleared an IRQ conflict with the mouse on COM 1. Running mouse drivers AND VGASPM.EXE fro
Electronics Forum | Fri Sep 26 08:11:15 EDT 2008 | dwelch123
Try swapping cards in Y1 enclosure. You can swap zero and one or two and three but make sure you change the shunt position and the dip switch settings and see if your problem switches cards. The lithium battery likes to fail on those cards. Reload th
Electronics Forum | Tue Mar 17 16:09:25 EDT 2009 | gregf912
For the IP3 to reliably place BGAs the machine needs the 4800 vision card and type 12 camera. From the problems i see here you must have the 4400 card and a type 8 or 9 camera. It would also seem that a calibration is in order. I have calibrated and
Electronics Forum | Fri Jun 03 14:21:48 EDT 2011 | rgduval
I haven't seen that particular fail....but... What was the failure with the M controller? Might try moving your MOT cards around, to see if the failure follows one particular card. If so, you'll know you need a new MOT card. That might satisfy th
Electronics Forum | Tue Mar 27 15:49:54 EDT 2012 | bradlanger
Try Re-seating the card that connects the ISA slot from the computer mother board to the I/O Dpram card. It may be worth checking the ISA card for bad solder joints. The computer mother board could be going bad. Check for vented electrolytic caps. Ho
