Electronics Forum | Thu Feb 11 16:33:08 EST 2010 | dougt
Contact Systems cs400e It's a semiautomatic thru hole machine that incorporates hand placement with a machine cut and clinch, was (probably still is) the benchmark in the industry.
Electronics Forum | Wed Jun 21 14:33:57 EDT 2023 | glr
You should a sequence that a D=2 Q=3 and X in going to be your bin location.
Electronics Forum | Wed Jun 28 12:04:28 EDT 2023 | nickadams
Thank you for your input. Do you know what might have caused this to happen? Just trying to prevent it from happening next time.
Electronics Forum | Tue Feb 08 10:25:46 EST 2011 | remullis
Michelle, It's been years since I worked on these machines and mine were CS400E's. The next time this error comes up instead of powering down Unplug the RS232 cable that links between the PC and the processor board in the machine, I cant remember if
Electronics Forum | Tue Apr 18 12:03:30 EDT 2023 | dskling
No. they struggle to move a little but not a full cycle. We have replaced the 3 control boards on the back door, both EMI filters, check and replaced all fuses, pulled the clinch head and swapped it with another working clinch head and that blew a c
Electronics Forum | Tue Feb 17 11:14:03 EST 2004 | remullis
Hi, I have worked with the CS400E's for 10+ years and normally when your having problems optically programming. The light bulbs are either getting dark or the filament is not positioned correctly. To set this, you will need a meter to check across
Electronics Forum | Wed Mar 10 08:08:49 EST 2004 | paul_bmc
I am having issues with a CS-400E that I thought I might ask if anyone has any suggestions. The machine may run fine for a while then out of the blue the cutters stop responding or start responding erratically, you have to hit the esc key after ever
Electronics Forum | Tue May 15 13:08:53 EDT 2012 | deanm
Dittos from A Very Frazzled Man. Money spent on a better process is almost always more advantageous than better inspection. As for manual TH insertion, have you considered a semi-automatic machine like the Contact Systems CS-400? While the "E" serie
Electronics Forum | Wed Mar 10 11:19:59 EST 2004 | mrmaint
Paul, I have seen harness issues in the past that have given some unusual results. The problem we found was that depending on the rotation and position of the cut/clinch unit the opens/shorts were not consistent. The first place i would look is at th
Electronics Forum | Tue Jun 27 20:24:56 EDT 2023 | auriga2001
If you're lucky, it's just a bad boot sector. You can take the drive out, hook it up to another computer and copy it before trying to fix anything. Then try to reinstall programs if you have them. If you're unlucky the hard drive died. You might be a