Electronics Forum | Tue Jan 10 22:10:29 EST 2012 | doncattoni
Hello Austin, Sorry for the delayed response. There are different types of cures for conformal coating such as RTV which stands for Room Temperature Vulcanising which means they are cured by the humidity in the air. This type of cure does not need
Electronics Forum | Tue Feb 07 05:41:20 EST 2012 | ngineer
I've got an issue, i can't seem to figure out. I think I need to apply a global offset to all my placements for some reason, and I would like to know why, before I do it. nozzles work, picks seem ok, but the placements are off by about 1/2 the widt
Electronics Forum | Mon Aug 12 15:56:13 EDT 2013 | pjchonis
Vapor phase soldering systems by Asscon are characterized by special designed heating modules. The thermal mass of the heating modules is designed so that a completely delay-less and direct regulation of the heat/flow/energy transfer to the soldering
Electronics Forum | Wed Oct 16 10:51:35 EDT 2019 | radialvalve
Hi Joe, sorry for the delay in responding to your request, hope it's not too late. There are several questions to be answered before we can guide you to the best solution to meet your Thermal Gel Dispensing Needs. I would like the opportunity to disc
Electronics Forum | Fri Jan 02 16:52:16 EST 2009 | boardhouse
Hi, From a Manufactures choice - Green is the best due to it is the most commonly used mask color in the industry & cheapest. Kind a like Red paint for Barns. For US shops, most only have one LPI machine and to continually switch from Green to othe
Electronics Forum | Sun Oct 21 22:10:37 EDT 2012 | eadthem
We have also experienced the same. a RAID array helps but there are a lot of static waits in Mirtecs software so it dosen't matter how fast you make the computer it still takes the same time to do a lot of waiting on the computer tasks. For exampl
Electronics Forum | Thu Jul 15 12:35:19 EDT 1999 | Earl Moon
| I use a Transition Automation Semi- Automatic stencil printer with laser cut frameless stencils. My solder paste is an SN63/PB37 RMA 291. I do not operate with in a controlled humidity enviroment. The room temp generally runs around 70 deg's but hu
Electronics Forum | Mon Jun 29 13:38:20 EDT 1998 | Russ Miculich
| looking for help with fine-pitch printing for what would be the best settings for printing speed, squeegee pressure, seperation speed. | thanks for you time Brian: As Justin says - the issues are many. However, a good start would be to run at 0.75
Electronics Forum | Tue Jul 16 07:33:32 EDT 2002 | pjc
Communication is the issue. What we have here is a failure to communicate....how does that song go? I implemented a system whereby incoming inspection would check component packaging to the spec. If it did not match they were to contact the process e
Electronics Forum | Mon Jan 13 17:50:54 EST 2003 | jonfox
I was looking for some good documentation that could nail down some pros/cons of voids, but haven't found any. The biggest issue is if you are going to temp cycle the chips/PCB after assembly. Depending on the cycle, the situation of the test, it c