Electronics Forum | Wed Apr 02 11:00:17 EDT 2014 | Beto Hdz
I need support to find out a good compact depanelling equipment that can be setup in a work cell as part of the final assy process for PCBs with scoring groove. If someone has experience with something similar any suggestion of guidance will be helpf
Electronics Forum | Wed Apr 16 12:50:56 EDT 2014 | comatose
We have several, the one everyone likes is a Fancort VPD5-330. We were having trouble with cracked ceramics near the score line with our pizza cutter style depaneler. The linear blade made it go away entirely. Not the cheapest, though.
Electronics Forum | Tue Jun 03 08:49:06 EDT 2014 | patel_daxa29
Check out the set up of Depanelizer. Try to cut at slower speed & check the blades to make sure it is not time to resharp the blades. If all this parameters OK I would sustect lamination process of board house.
Electronics Forum | Thu Jun 05 10:17:12 EDT 2014 | swag
Can you cut v-scores deeper to resolve the issue then build carriers to support the panel? I would say that we usually build carriers for anything that thin regarless of the depanel method.
Electronics Forum | Tue Jun 10 21:15:01 EDT 2014 | comatose
We had a similar problem once, it was due to insufficient v-score depth. While waiting for remade PCBs we would run an exacto knife along the score lines prior to depanel to cut a little deeper. Not ideal for sure, and not fast, but it worked.
Electronics Forum | Fri May 29 07:17:30 EDT 2015 | kkay
We have a small board about 1" by .5" and it is .012" thick. It is in a 50 up panel. We have tried rat bites and v-score and we keep seeing delamination around the edges. Anyone have experience depaneling boards this thin?
Electronics Forum | Thu Apr 14 14:16:22 EDT 2016 | joelperez
Has anyone use both methods of depaneling on PCB breaktabs? meaning v-score at the edge of the pcb and mouse bites on the opposite side of the tab (break out panel)? Thanks
Electronics Forum | Fri Jun 03 09:33:44 EDT 2016 | sumote
If you end up buying a depaneling machine/robot, the guys at Pentagon EMS are very good at making fixtures. Once they have the specifications of your machine all you will have to send them is your panelized drawing of your board. In extreme cases you
Electronics Forum | Thu May 04 13:35:28 EDT 2017 | jmathis
Hello All, I was given an assembled flex circuit PCB and asked how the board was depanelized as there are no view-able witness marks that I can see. Any ideas? Thanks in advance on any insight to depanelizing without leaving witness marks on the F
Electronics Forum | Wed May 31 07:16:06 EDT 2017 | stephendo
Don't rule out the possibility that the board shop depanelized it and it was assembled after depanelization. Been there, dealt with it, expletives deleted.
Depanelizer Equipment and Tools For Electronic Assembly. PCB Racks and Trays. Wire Crimp Press and Tooling.
115 Pleasant Street
Millis, USA
Phone: 508 376 2500