Electronics Forum | Sun May 09 09:23:27 EDT 2004 | Sam
Harry, Yes, the model is AP-20 and the computer is 386. I think the system disk was damaged by floppy driver that did not do the maintenance before reading the disk. I have do the test with the common disk that insert to the driver after do maintena
Electronics Forum | Mon Jul 25 18:30:54 EDT 2005 | grantp
Hi, I know this is not exactly SMT related, but it's the right group to ask, but we need better powered screw drivers, as the electric ones we have the girls are having difficulty screwing in the plastic screws we use. Can anyone recommend good sc
Electronics Forum | Sat Jun 28 07:29:36 EDT 2008 | proy
Chris I got both my SPMs running. The one with the touch screen; I think the touch sensor is worn out, 1 in 10 trys we can select the MAINTENANCE menu and run RESET properly, other areas always select fine. Your problem sounds like it is missing
Electronics Forum | Tue Jan 13 08:08:37 EST 2009 | leemeyer
I am assuming that the card that was changed was the motor driver card. Did they change the card with a known good board or just swap the X and Y cards. If they swapped cards it appears that the card that is now in the X motor slot is bad. Open the a
Electronics Forum | Wed Oct 20 11:14:55 EDT 2010 | swag
I hope you're fixed by now but my advice is to pull all connectors from drivers and reseat. Also, reseat connectors in I/O area + I think there's some cards that relay power to various axis in this area. Reseat all connectors. From my experience,
Electronics Forum | Thu Sep 24 00:52:41 EDT 2015 | ermani9
Hi.. Move the XY arm to the center of the machine. Turn on the servo then immediately hold “LOWER” then press “ORIGIN”. You should see the message now on the screen “DRIFT CHECK”. The arm will start to drift without an emergency condition occurr
Electronics Forum | Sat May 14 12:28:49 EDT 2016 | dilogic
Any ideas that can cause y-axis resonance? I ruled out all usual the suspects (tacho sensor, driver cards, motor driver etc.). Looks like some mechanical issue, but can't figure it out. I suspect leadscrew nut - I checked it with motion diagnostics s
Electronics Forum | Tue Mar 02 02:52:09 EST 2021 | dekhead
I assume you are saying that the rail width doesn't initialise when you initialise machine, but when you go into diagnostics and then exit diagnostics it initialises properly. (Not sure what cycling board on belts has to do with it). Have seen, on mu
Electronics Forum | Fri Nov 12 09:08:54 EST 1999 | mart weakley
Has anyone put together all the key parameters/drivers for voids on high density BGA's?? Thanks, Mart Weakley
Electronics Forum | Wed Oct 09 16:46:10 EDT 2002 | davef
Search on "display driver" at: * Newark [ http://www.newark.com/ ] * Digikey [http://www.digikey.com/ ]
WINTECH provides new/used/pre-owned SMT, AI & PCB Assembly (PCBA) equipment of various brands. Also supply service, modification & original or local-made spare parts. We are also an appointed agent for well-known brands.
Equipment Dealer / Broker / Auctions
NO. 1 LORONG SAGA JAYA 6
PERAI, 09 Malaysia
Phone: 6043809899