Electronics Forum | Mon May 30 15:55:28 EDT 2022 | spoiltforchoice
~Except that would appear to be a language things, it says AOI, it means SPI. Presumably very much 2D not 2.5 or pseudo 3D too (not that such is relevant)
Electronics Forum | Mon Jun 13 15:27:15 EDT 2022 | llawrence
No there are no pads except for the castellated ones on the side. These boards are being used on agricultural machinery though so a less than ideal solder joint would likely be prone to failure over time
Electronics Forum | Fri Jan 06 12:21:44 EST 2023 | jdengler
I would wait. Scrap the bare boards you have and order fresh boards to arrive when the late component is scheduled to arrive and run as normal. Unless the bare board is exceptionally expensive this is the cheapest and safest route to take. Jerry
Electronics Forum | Tue Apr 25 22:14:05 EDT 2023 | spoiltforchoice
Isn't it a pain? At least TI have a proper page for lookups, they might be an exception however. The other one that gets me, is when a supplier sends something completely wrong and then says, "what did we send you?" Your problem mate, note mine.
Electronics Forum | Thu Aug 17 14:35:47 EDT 2023 | lauri
Thanks for the response. We have checked everything except the stepper motor, which we will try. But as we were checking everything now we've developed a software (?) problem. A msg comes up "can't find DSP".
Electronics Forum | Tue Mar 04 18:49:06 EST 2003 | scifi97
Hi Mike, I have had a number of contract manufacturers, and SMT equipment makers looking at using our SPC software to monitor process control on SMT machine production with the data coming off the vision check machines. (There seems to be a huge sur
Electronics Forum | Mon Aug 11 17:48:39 EDT 2003 | Brian W.
Assuming you are working to IPC standards, are you working to Class2 or Class 3? Class 2 has an exception to the 75% barrel fill (para 6.3.1, page 6-7). "As an exception to fill requirements of Table 6-2 on PTHs with thermal planes or conductor
Electronics Forum | Thu May 13 01:14:37 EDT 2004 | vincent
hi, i have a question relating to fiducial, is the fiducial normally comes with the pick and place data from the custommer or we have to define it by ourself? how to set its coordinate so that the cp6 and ip3 (using Fujicam software) will be able to
Electronics Forum | Sun Jul 08 06:38:41 EDT 2007 | dilogic
We have an old GSM1 (I-block, USOS V1.4.14, two 4-spindle heads, changers between rails). When I configure machine so there are no nozzles on heads and changers are filled with required nozzles, except for one empty hole, machine won't pick up nozzle
Electronics Forum | Mon Oct 24 16:20:31 EDT 2022 | rgduval
yup...I've always ignored rated cph reported by the manufacturer. In the case of MyData's, the only way to approach the rated cph is to load the same part in multiple feeders next to eachother, and place it a million times...that way Hydra can gang