Electronics Forum | Wed Jun 27 08:33:27 EDT 2007 | pekantol
Have you measured the preQ rotation station(st3).Is it workin correctly?
Electronics Forum | Thu Jan 24 10:27:09 EST 2008 | vikkaraja
Sorry I did not response to you sooner. I will do my best to get that info. to you as soon as possible.
Electronics Forum | Thu Jun 25 08:34:31 EDT 2009 | cyber_wolf
Banging and knocking is not good. The noise that we hear on ours is more of a whining. .1mm runout and rough edges = time to replace in my opinion.
Electronics Forum | Tue Jul 13 10:51:55 EDT 2010 | muarty
Sounds pretty much like the sensors/amplifiers need tuned on your machine. It is a fairly straightforward exercise to do this. The sensors basically look at the back of the chucks to determine which nozzle is in the lowest position and therefore whic
Electronics Forum | Wed Apr 16 16:58:00 EDT 2014 | jimmyboz
My first guess, loose wire or bad cable. Email me and I will send you a checklist.
Electronics Forum | Mon Jun 29 09:23:59 EDT 2015 | tnisbet
We service MPM machines. Tom Nisbet tom@goppm.com 603 765-8814 www.goppm.com
Electronics Forum | Mon Aug 29 11:39:23 EDT 2016 | tdemon69
I was wondering if you could help me with my Panasonic MV. it is throwing parts around after it picks them up . only have 3 heads work in it.
Electronics Forum | Fri Apr 24 17:42:04 EDT 2020 | rodrigo
I checked and the fine theta motor is spinning. Thank you so much for the help.
Electronics Forum | Fri May 08 17:55:37 EDT 2020 | cyber_wolf
The squish is determined by the spring in the nozzle. If Z0 or table level is out, you would see it on more than one component..most likely Make sure board thickness and component height are correct. Also make sure you have board support installe
Electronics Forum | Wed Jul 28 16:15:45 EDT 1999 | J. Robotham
Dear Forum Members, Is their anyone who is familar with 1005 placement using a Fuji CP3 and a CP4-3 to perform at CP642 spec's? I have heard of a number of companies doing this. Are there any tech sheets or other site's that may have this procedur