Electronics Forum | Wed Nov 19 10:57:55 EST 2014 | jimmyboz
Oh yeah, You can flip to switch on the camera card, VM1710 and jog the PCB under the fiducial camera to visually inspect to placements. switch it back when you are done.
Electronics Forum | Sat Nov 08 21:48:42 EST 2014 | sonavc
ETC then you see TEACH. But I can't see it. Do my machine need to update the software or chane some thing in the Proper program?. I'm using MCS16 computer. So far the machine runs great , But take me awhile to move to correct fiducial location Thank
Electronics Forum | Thu Nov 13 13:12:57 EST 2014 | jimmyboz
Are you using MCS1 or MCS2 software on the MCS16? For MCS1 I would have to try and remember, haven't seen that software in 20 years. For MCS2 in the PD make sure nozzle size, nozzle size min, and nozzle size max are all set to Med.
Electronics Forum | Wed Aug 27 12:15:15 EDT 2014 | jimmyboz
I understand what you want, I do not however, understand why? I have checked some documentation and found nothing. If I know why, I might try harder for a solution. It doesn't seem like time is crucial, else you want to pre-pick. Two easy ways ar
Electronics Forum | Wed Aug 27 12:38:48 EDT 2014 | fuji_user_2014
We do a lot of low volume prototypes and several boards that have have cut outs or fixtures that dont always reliably stop squarely at the in carrier (beveled corners). This sometimes results in a fid read error, because the fid wont be in the search
Electronics Forum | Mon Nov 07 16:31:47 EST 2005 | CW
hi Bob, Thanks for the info. I understand your comments, but I am looking for specific guidance, If I am putting chip capacitors on a .063 FR4 board, what size package should we stay away from to avoid cracking? (I realize this is dependent on h
Electronics Forum | Mon Nov 10 09:11:51 EST 2014 | rgduval
The centering jaws are made out of copper, I believe...and conductive. I'd suggest that the conductivity of the copper makes it a fairly poor source of ESD damage in a component. I have observed physical damage to components from the centering jaws
Electronics Forum | Tue Nov 08 05:00:23 EST 2005 | rlackey
Hi CW, Regarding orientation, yes, your diagram is right - see the following link for confirmation. http://search.murata.co.jp/Ceramy/image/img/A18X/C2EB3C.PDF Regarding information on bending strength you want to talk to your local Murata office
Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has
Electronics Forum | Tue Jun 20 21:42:19 EDT 2023 | jdengler
The MTU has it's own proper data file. You need to send that to the MTU.