Electronics Forum | Fri Jun 23 12:54:53 EDT 2017 | guts1872
We are having issues with top fill and dropping pins on Molex connectors with our KISS 101. Unfortunately we do not have a pre heater and bottom side pre heat with our nozzles is not satisfactory. Most of the issues occur when using a no clean proces
Electronics Forum | Wed Jan 23 20:01:20 EST 2019 | padawanlinuxero
Hello Sounds to me that the problem might be with vaccum and lot of it, after the component is place theres a small amount of air that pushes the component away from the nozzle in MYDATA we call it a kiss in my facility, have you check that the air
Electronics Forum | Wed Jan 30 00:56:00 EST 2019 | kiransahu
Sounds to me that the issue may be with vacuum and part of it, after the segment is put there's a little measure of air that pushes the segment far from the spout in MYDATA we consider it a kiss in my office, have you watch that the air that "puffs"
Electronics Forum | Fri Jul 22 11:47:01 EDT 2022 | tpratt
I got your email and responded a few times. I asked you another question via email, but you can ignore it if you find it because I managed to figure it out. I really can't thank you enough, I never would have figured out the calibration issue witho
Electronics Forum | Fri Mar 17 14:59:50 EDT 2023 | proceng1
OK, does your axis screw have the flex coupler or the magnetic coupler? Which axis is it? Did you turn off soft limits? If it's out of range, soft limits won't let it move by controls. I need to know which axis before I can get too far into this. I
Electronics Forum | Wed Dec 20 20:24:45 EST 2023 | ronh22
Looking for some Recommendations for a Selective Solder machine. We currently have a KISS103 no pre heater. We are high mix low volume, so batch is most like best option. I have used Pilerhouse Jade MKII years ago. Wondering what other option pe
Electronics Forum | Thu Apr 04 19:13:51 EDT 2024 | proceng1
My original GECKOs all had labels marking them [X, Y, Z, SP] I believe the fuses holders did also. I used a mirror on a stick and I took a set of plastic handle precision screw drivers and cut the handles in half in order to be able to work the smal
Electronics Forum | Fri Dec 27 12:53:38 EST 2019 | rgduval
yeah...I never had airflow volume problems with Hellers. When I had to build the system I was referring to, we had an old Speedline oven, and the way it was configured if you didn't provide enough airflow to the outer cavity, the blowers would overh
Electronics Forum | Thu May 03 10:16:45 EDT 2001 | caldon
I like the Glenbrook x-ray systems. Simple and easy to use and they have a great support staff. We are using the Jewel Box 70 and are extremely pleased with it. They have complimentary software for analyzing the balls that is excellent. For the price
Electronics Forum | Wed Sep 24 08:34:57 EDT 2003 | stefwitt
Even when you run a board several times, the machine may not make the same travel path every time. This in itself does not create a problem, but the vacuum on the nozzles could be different, dependent on the configuration of components on the heads.
.gif)
