Electronics Forum | Thu Jun 10 13:29:21 EDT 2021 | edgar_smt_ap
Good morning. What should be the Oxygen content Standard in an Oven? Here in my company, we have an ERSA reflow Oven, and we work with Lead Free solder paste. According to Work Standard documents send by my company corporate, the PPM Oxygen conte
Electronics Forum | Mon Sep 27 10:35:31 EDT 2004 | grayman
ersa is one of the best machine in the industry now. However, price and after sales service is no good. I suggest you buy a low cost China made reflow oven. I know China made reflow oven cost at $20k for a 5 zones lead free Arman
Electronics Forum | Tue Jul 21 05:08:16 EDT 2020 | arty vesna
Hi there. I am currently kinda in the same spot as the author of the thread. My choice is between Rehm VXC and Heller 1809. I am a little concerned about Heller advertising their 25cm/10 in zones. I am used to large ovens designed for high throughput
Electronics Forum | Tue Oct 05 22:36:37 EDT 2004 | fastek
Who can blame anyone for having lousy service in China when there's twenty companies selling cheap throw away ovens for $20K new. What's surprising is why would BTU, Ersa, Vitronics and Heller even try to sell over there anymore.
Electronics Forum | Wed Jul 09 16:09:47 EDT 2003 | russ
I would always recommend that an oven be used. I am not familiar with the ERSA rework system so I cannot comment. The key is to heat evenly with the correct ramp rate. If your rework station does this well then use it. if not I would put through t
Electronics Forum | Tue Aug 27 16:39:39 EDT 2019 | spoiltforchoice
There is no formula out there that chooses a model for low volume high mix. Every oven can manage the throughput, which leaves us with cost, servicing, flexibility and reliability. Ersa Pros: Longer heated length than the ovens I am comparing it t
Electronics Forum | Fri Nov 07 23:40:41 EST 2008 | padawanlinuxero
I have been working on the SMT area for a while now, must of my experience is on programming and pick and place, now in my new job I have to control a complete SMT line and I have a little knowledge on working with solder paste but I like to read mor
Electronics Forum | Mon Oct 16 05:31:43 EDT 2006 | vasily
Hi Stano You put "cold" PCB into the oven. What do you expect? Of course the temperature will go down. I don't think it affects the final result of soldering.
Electronics Forum | Wed Dec 17 08:43:14 EST 2008 | stiva
Have seen this problem on other types of oven and it was caused by failed solid state relays that energise the heaters.
Electronics Forum | Mon May 29 04:02:51 EDT 2006 | vasily
Hi Efren Unfortunately I cannot say about prices, because I don't know them in your region. But I can offer you to consider the world-leader manufacturers of each type of equipment. I think you can obtain all information through their web-sites. We s
